- •Product Description
- •Safety and General Information
- •Product Overview
- •Front panel features
- •Rear panel features 500 VA to 1500 VA models
- •Connect Equipment
- •Rear Panel Features
- •Display Panel
- •Using the display interface
- •Standard menus
- •UPS Settings
- •Start-up Settings
- •General Settings
- •Main Outlet Group and Switched Outlet Group
- •Using the Main and Switched Outlet Groups
- •Customize the Main and Switched Outlet Groups
- •Network Management Card Settings
- •Emergency Power Off
- •Normally open contacts
- •Normally closed contacts
- •Transport the unit
- •Smart-UPS Factory Warranty
- •LIMITED WARRANTY
Uninterruptible Power Supply
750/1000/1500/2200/3000 VA Tower 100/120/230 Vac
500 VA Tower
The APC® by Schneider Electric
Safety and General Information
Read the Safety Guide included in the package before installing the UPS.
This unit is intended for indoor use only.
Do not operate this unit in direct sunlight, in contact with fluids, or where there is excessive dust or humidity. Be sure the air vents on the UPS are not blocked. Allow adequate space for proper ventilation.
The battery typically lasts for two to five years. Environmental factors impact battery life. Elevated ambient temperatures, poor quality utility power, and frequent short duration discharges will shorten battery life.
For additional specifications, refer to the APC Web site at www.apc.com.
0° to 40° C (32° to 104° F)
charge UPS battery every six months
3,000 m (10,000 ft)
15,000 m (50,000 ft)
0% to 95% relative
Front panel features
Internal battery connector
Rear panel features 500 VA to 1500 VA models
USB portSerial port
Ground screwSmart slot
Circuit breakerUPS input
Internal or external battery connector
500/750 VA 100 Vac
750 VA 230 Vac
750 VA 120 Vac
1000/1500 VA 100 Vac
1000/1500 VA 230 Vac
1000/1500 VA 120 Vac
1 PU OR G
Rear panel features 2200 VA and 3000 VA models
2200 VA 120 Vac
Serial portGround screwSmartSlot
Circuit breakerUPS input
2200/3000 VA 100 Vac
2200/3000 VA 230 Vac
3000 VA 120 Vac
P U O R G
For UPS installation information, refer to the
Note: The UPS will charge to 90% capacity in the first four and a half hours of normal operationfor the 2200/3000 VA 100 Vac model or the first three hours of normal operationfor all other models.Do not expect full battery runtime capability during this initial charge period.
1.Connect equipment to the UPS.
2.Connect the UPS to the building utility power. Connect the UPS to a
3.To use the UPS as a MASTER ON/OFF switch, turn on equipment that is connected to the UPS.
See “Main Outlet Group and Switched Outlet Group” on page 9 for information on how to configure the outlet groups.
Rear Panel Features
Serial port: Connect to a computer to use power management software.
USB port: Connect to a computer to use power management software.
Ground Screw: Connect the ground leads on transient voltage devices to the chassis ground screw(s), located on the rear panel of the UPS.