AOpen DVD9532 User Manual
C o p y r i g h t
Copyright ã 1998 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of this company.
D i s c l a i m e r
This company makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Any software described in this manual is sold or licensed "as is". Should the programs prove defective following their purchase, the buyer (and not this company, its distributor, or its dealer) assumes the entire cost of all necessary servicing, repair, and any incidental or consequential damages resulting from any defect in the software. Further, this company reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation to notify any person of such revision or changes.
Federal Communications Commission
Radio Frequency Interfaces Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used in accordance with the instruction manual may cause harmful interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measured:
qREORIENT OR RELOCATE THE RECEIVING ANTENNA.
qINCREASE THE SEPARATION BETWEEN THE EQUIPMENT AND RECEIVER.
qCONNECT THE EQUIPMENT INTO AN OUTLET ON A CIRCUIT DIFFERENT FROM
THAT TO WHICH THE RECEIVER IS CONNECTED.
qCONSULT THE DEALER OR AN EXPERIENCED RADIOTV TECHNICIAN FOR HELP.
This changes or modifications not expressly approved by this party responsible for compliance could void the user’s authority to operate the equipment.
Drive Interface Type
Disc Data Capacity
Single Layer 4.7GB
(mode 2, form 1 and form 2),
Video CD, Enhanced Music CD
16 bit linear
First, turn off the system power, then please follow below steps to install the DVDROM drive.
1.Adjust the Master/Slave jumpers on the rear side of the
3.Plug connectors to the sockets on the rear side of
NOTE: Normally, the red edge of the IDE cable corresponds to pin 1 of the IDE interface on the
In most cases, software applications that utilize
1. Locate the tiny hole at the bottom of the disc tray. Gently poke the hole with a sharp needle or a clip.
2. When the disc tray opens, pull out the tray and remove the disc from the