Antec NEOPOWER 550 User Manual
Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario
High efficiency modular power supply
This manual covers the entire family of NeoPower power supply units (PSU). This line of PSU has increased output power distribution. The NeoPower (except
the NeoPower 430) features ATX12V version 2.2/ EPS12V specifications to match the newest Intel® and AMD processor requirements. Furthermore, it includes three +12V outputs that deliver safer and more reliable power to your system’s components. NeoPower generates less heat because of high efficiency technology. This keeps the power supply itself cooler and prolongs its working life. It also includes a variety of
Special Quiet Computing™ fan operation
NeoPower PSUs feature an innovative design to help decrease noise during normal use, but still allow for superior cooling capabilities as loads increase. With its high efficiency and low heat generation, the power supply utilizes a 12cm fan.
The fan rotates slowly and quietly to blow hot air out of the power supply, speeding up as heat increases. The NeoPower feature Universal Input, which allows you to connect the power supply to any AC power source between 100~240V without having to worry about setting a voltage switch. This power supply also features Active PFC, which improves the power factor value of the power supply by altering the input current wave shape and thus helps transmission across the power grid.
Advanced cable management system
NeoPower PSUs feature Antec’s advanced cable management system, which allows you to use only the power cables that you need, thereby reducing clutter and improving airflow inside your case. Inside the package, apart from a power cord, you will find the following:
Modular Cable Set
1.There will be two sets of cables with three standard
3.NeoPower 430 and 650 include one
4.Two sets of cables with two SATA drive connectors at one end and a
1.Install the NeoPower® PSU into your case with the four screws provided.
Note: Please also refer to your motherboard user guide for any special instructions.
4.Connect the cables from cable pack to the socket on the power supply as needed. If you are using the PCI Express cables, make sure that the end of the cable labeled
5.Connect the AC power cord to the power supply AC inlet and turn the switch to “I” position.
430) and a
has a 6+2
77 cm Molex
78 cm Serial ATA
14 cm Molex to
Includes one Molex
and two Floppy
60 cm PCI Express
connector w/ cable
430 and 650 only
47900 Fremont Blvd.
Fremont, CA 94538
Antec Europe B.V.
3047 AS Rotterdam
tel: +31 (0) 10
US & Canada
+31 (0) 10
© Copyright 2007 Antec, Inc. All rights reserved.
All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China.