Antec Basiq BP430 User Manual

Size:
143.69 Kb
Download

Basiq

BP430

User’s Manual

Manuel de l’utilisateur Anwenderhandbuch Manuale per l’operatore Manual del usuario

Antec Basiq User’s Manual

ATX12V version 2.2 power supply

Model BP430

Antec Basiq series power supplies are built to be compatible with the ATX12V version 2.2 specification. They include two 12V output circuits that deliver safer and more reliable output to your system’s components. In addition we’ve included a variety of protective circuitry: OCP (Over Current Protection),

OVP (Over Voltage Protection), and SCP (Short Circuit Protection).

BP430 includes Universal Input with Active Power Factor Correction (PFC). Universal Input allows you to connect your Antec Basic power supply to any AC power outlet between 100~240V without having to worry about setting a voltage switch. Active PFC improves the power factor value to the power supply by altering the input current wave shape, helping the power plant provide power to users more efficiently.

Power Switch:

This power supply comes with a main power switch. Make sure you turn the switch to the ON ( I ) position before you boot up your computer for the first time. In normal operation there is no need to turn the switch to the OFF (O) position since the power supply is equipped with a soft on/off feature which turns your computer on and off through the soft switch on your computer case. You may need to turn the switch to the OFF position occasionally should your computer crash and you cannot shut it down through use of the soft switch.

Installation:

1.Turn off the hard power switch on your old power supply if any.

2.Open your computer case. Follow the directions provided in your case manual.

3.Disconnect all power connectors from the motherboard and from the peripheral devices such as case fans, hard drives, optical drives, floppy drives, etc.

4.Disconnect the power cord from your old power supply.

5.Remove the existing power supply from your computer case and replace it with your new Antec power supply. (Illustration 1)

1

6.Turn the hard switch on the Antec power supply to the OFF (O) position and connect the AC power cord to the power supply.

1

7.Connect the 24-pinMain Power Connector (Illustration 2). If the motherboard uses a20-pinconnector, detach the4-pinattachment on the24-pinpower connector (see pictures 1 and 2).

Note: the detachable4-pinsection cannot be used

Picture 1

Picture 2

in place of a 4-pin+12V connector.

d

For 24-pin

For 20-pin

motherboards

motherboards

8.Connect the 4-pin(Illustration 3) 12V connector to the motherboard as

needed.

3

9.If your video card requires a PCI-EConnector, then connect the cable from the main wire bundle to your video card.

10.Connect the Drives and Accessories Cable to devices such as hard drives, optical drives, fans, etc.

11.Connect the SATA cable if you are using a Serial ATA hard drives.

12.Close your computer case.

2

Antec, Inc.

47900 Fremont Blvd.

Fremont, CA 94538

USA

tel: 510-770-1200

fax: 510-770-1288

Antec Europe B.V.

Stuttgartstraat 12

3047 AS Rotterdam

The Netherlands

tel: +31 (0) 10 462-2060fax: +31 (0) 10437-1752

Customer Support:

US & Canada

1-800-22ANTECcustomersupport@antec.com

Europe

+31 (0) 10 462-2060europe.techsupport@antec.com

www.antec.com

© Copyright 2008 Antec, Inc. All rights reserved.

All trademarks are the property of their respective owners. Reproduction in whole or in part without written permission is prohibited. Printed in China.