American Standard 1340 Series User Manual
SINGLE TAP PUSH BUTTON FAUCET
1340 SERIES FOR COLD AND TEMPERED SUPPLIES
1340M SERIES INCLUDES BELOW DECK MIXING VALVE WITH STRAINER
Certified to comply with ANSI A112.18.1M
U.S. PATENT NOS.
Thank you for selecting
To ensure that your installation proceeds
WARNING: SUPPLY INLET MUST BE FILTERED WITH A 60 MESH SCREEN.
USE AMERICAN STANDARD MIXING VALVE WITH STRAINER OR COMMERCIAL 60 MESH STRAINER.
0 1 2 6 9 2 D
BILL 1340M SERIES
1 ASSEMBLING ESCUTCHEON KIT (OPTIONAL)
Turn off hot and cold water supplies before beginning.
Peel off paper backing from PADS and stick both PADS to underside of ESCUTCHEON about 1/4" from ends.
Peel off paper backing from WASHER and stick
WASHER into circular groove of SUPPORT PLATE.
Place SUPPORT PLATE in center
of ESCUTCHEON with WASHER visible.
Apply a bead of PUTTY around
the inside of ESCUTCHEON edge.
Turn ESCUTCHEON over and
center it with SUPPORT
PLATE over center hole
of sink deck.
ASSEMBLING MOUNTING KIT
Thread (3) SCREWS into LOCK RING.
SCREWS should extend
3 MOUNTING FITTING
Install faucet through the ESCUTCHEON being sure the rubber GASKET is between the FAUCET and the ESCUTCHEON.
Install brass WASHER and turn
Tighten (3) SCREWS in the
FOR 1340 SERIES ONLY
Warning; 60 MESH STRAINER required for supply water.
Install RISER TUBE (not included) and tighten SUPPLY NUT.
Connect RISER TUBE to COLD or TEMPERED water supply.
FOR 1340M SERIES
Connect FLEXIBLE FAUCET SUPPLIES (1/2" faucet cone on one end, 3/8" compression on the other) to the MIXING
VALVE INLETS and the
hot/cold wall stops.
The FLEXIBLE FAUCET
SUPPLIES are NOT
included. Turn on WALL
STOPS and check
With WALL STOPS open and water flowing, adjust MIXING VALVE to temper water.
4 TO OPERATE
Lift off retaining
ring then slide
Press down to start.
Cycle time is factory set but can
be changed as shown.
5 TO SERVICE
TO remove HANDLE use a 3/32" ALLEN WRENCH to loosen three set screws in the HANDLE as shown in Figure A.
Remove VALVE CARTRIDGE for cleaning or replacement, see in Figure B.
Reassemble in reverse order, Figures C & D.
3/32" ALLEN WRENCH
6 SPRAY INSTALLATION/REMOVAL
Use included key to install SPRAY into spout end.
HOTLINE FOR HELP
Weekdays 8:00 a.m. to 7:00 p.m. Eastern Time
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
All dimensions are approximate and for reference only.
C A m e r i c a n S t a n d a r d I n c . 1 9 9 6
0 1 2 6 9 2 D