American Power Conversion ACCH167, 30RAN050, ACCH084, 30RAN025, 30RAN015 User Manual

...
0 (0)

Supplemental Installation Information for APC Chillers

This document contains reference information needed to connect APC equipment to APC chillers.

All water and electrical connections must be performed by a qualified contractor in accordance with local and national codes.

Warning

Model Cross Reference Information

APC MODEL NUMBER

CARRIER MODEL NUMBER

 

 

ACCH050

30RAN015

 

 

ACCH084

30RAN025

 

 

ACCH120

30RAN035

 

 

ACCH167

30RAN050

 

 

American Power Conversion ACCH167, 30RAN050, ACCH084, 30RAN025, 30RAN015 User Manual

Typical Piping — Chiller to Cooling Distribution Unit (CDU)

 

 

 

CHILLER

RC

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CDU

Components inside dashed lines are included with the chiller, InfraStruXure InRow RC, and CDU. All other items (valves, piping, etc.) are customer-supplied.

Note

 

Pressure reducing/fill valve

 

Pressure gauges/petcocks

 

Air separator and vent*

 

Heat exchanger

 

Flex connections

 

Flow switch

 

Isolation valves

 

Balance valve/drain plug

 

Strainer/blow-down valve

 

Storage tank**

 

Expansion tank

 

3-way valve

 

Dual pump

 

Bypass line

 

Electric heater

 

Flow meter

Air vent connection port

* Install at the highest point in the system.

**To provide the coldest possible water to the load, install the optional storage tank on the leaving side of the chiller

2

Supplemental Installation Information for APC Chillers

Typical Piping — Single Chiller

CHILLER

CRACs

Components inside dashed lines are included with the chiller and CRACs. All other items (valves, piping, etc.) are customer-supplied.

Note

 

Pressure reducing/fill valve

 

Electric heater

 

Air separator and vent*

 

Air vent connection port

 

Flex connections

 

Pressure gauges/petcocks

 

Isolation valves

 

Heat exchanger

 

Strainer/blow-down valve

 

Flow switch

 

Expansion tank

 

Balance valve/drain plug

 

Dual pump

 

Storage tank — optional**

* Install at the highest point in the system.

**To provide the coldest possible water to the load, install the optional storage tank on the leaving side of the chiller

Supplemental Installation Information for APC Chillers

3

Loading...
+ 5 hidden pages