Amana AFI2538AE User Manual

Size:
82.83 Kb
Download

®

Bottom Mount Refrigerator

PRODUCT MODEL NUMBERS

AFI2538AE

Electrical Requirements: A 115-volt, 60-Hz, AC-only, 15or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned

off by a switch. Do not use an extension cord.

NOTE: Before performing any type of installation, cleaning, or removing a light bulb, turn the control (Thermostat, Refrigerator or Freezer control depending on the model) to OFF and then disconnect the refrigerator from the electrical source. When you are finished, reconnect the refrigerator to the electrical source and reset the control (Thermostat, Refrigerator or Freezer control depending on the model) to the desired setting.

Water Supply Requirements: A cold water supply with water pressure of between 35 and 120 psi (241 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber.

IMPORTANT: The pressure of the water coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the system needs to be a minimum of approximately 40 to 60 psi (276 to 414 kPa).

PRODUCT DIMENSIONS

B

A

D

(including

overall

handle)

 

C top of cabinet

Model #

Depth

Cab. Width

Cab. Height

Overall Height

 

"A"

"B"

"C"

"D"

 

 

 

 

 

AFI2538AE

35-1/4"

35-5/8"

68-5/8"

70-1/8"

 

(89.5 cm)

(90.5 cm)

(174.3 cm)

(178.1 cm)

 

 

 

 

 

LOCATION REQUIREMENTS

To ensure proper ventilation for your refrigerator, allow for a 1/2" (1.3 cm) space at the top and behind the refrigerator. If your refrigerator has an ice maker, allow extra space at the back for the water line connections. When installing your refrigerator next to a fixed wall, leave 3-3/4"(9.5 cm) minimum space

¹⁄ " (1.3 cm)

between the refrigerator and wall to allow the door to swing open.

NOTE: It is recommended that you do not install the refrigerator near an oven, radiator, or other heat source. Do not install the refrigerator in a location where the temperature will fall below 55°F (13°C).

3³⁄ " (9.5 cm)

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Ref. W10175442A

Instructions packed with product. Specifications subject to change without notice.

09-11-08