Allied Telesis Converteon AT-CV5000- User Manual
Size:
5.66 Mb
Download

AT-CV5000Media Converter Chassis Installation Guide

AT-CV5M01Management Card

PWR LED is

OFF

RDY LED is

Blinking

RDY LED is OFF

FLT LED is

Blinking

If the PWR LED on an AT-CV5M01card is OFF, perform the following:

If the chassis is installed on a desktop, check to be sure that the power adapter is securely connected to a power outlet and that the power adapter cable is securely connected to the rear of the converter.

Verify that the power switch is turned ON.

Verify that the power outlet has power by connecting another device to it.

Try using another power adapter.

If the RDY LED on an AT-CV5M01card is blinking, perform the following:

Verify that the settings on the DIP switches and jumpers are correct.

Try using the default settings.

Remove and re-insertthe card.

If the RDY LED on an AT-CV5M01is OFF, perform the following:

Verify that the card is firmly inserted in the slot.

Remove and re-insertthe card.

Verify that at least one power supply in the rear of the converter is operational.

Make sure that the power cord is securely connected to the power source and to the AC connector on the rear panel of the switch.

Verify that the power outlet has power by connecting another device to it.

Try connecting the unit to another power source.

Try using a different power cord.

Check that the voltage from the power source is within the required levels for your region.

If the FLT LED on a line card is blinking, no action is required. A blinking FLT LED could indicate that a new version of the management software is being downloaded to the converter or that the converter’s configuration is being changed, such as with the installation of a new line card. The LED will stop blinking after the converter has completed the download or the configuration change is completed.

97