Allied Telesis Converteon AT-CV5000- User Manual
Size:
5.66 Mb
Download

Chapter 3: Working with Line Cards and other Modules

Working with the AT-CV5M01Management Card

Installing an

AT-CV5M01

Management

Card

This section contains the following procedures:

“Installing an AT-CV5M01 Management Card,” next

“Resetting an AT-CV5M01 Management Card” on page 77

“Replacing an AT-CV5M01 Management Card” on page 78

This section describes how to install an AT-CV5M01Management Card.

Note

The AT-CV5M01Management Card ishot-swappable.You can install it without powering off the Converteon™ chassis.

Warning: Remove all metal jewelry, such as rings and watches, before installing or removing a line card from apowered-onchassis. E26

Caution: Be sure to observe all standard electrostatic discharge (ESD) precautions, such as wearing an antistatic wrist strap, to avoid damaging the device. A line card can be damaged by static electricity.

To install an AT-CV5M01Management Card, perform the following procedure:

1.Remove the AT-CV5M01Management Card from its shipping package and store the package in a safe place.

Note

You must use the original package if you need to return the unit to Allied Telesis.

2.Select any line card slot in the AT-CV5000chassis where you want to install the management card and remove the slot cover, if installed.

3.Align the back edge of the management card with the top and bottom alignment guides located inside the slot.

Note

Avoid touching the line card components.

76

Resetting an

AT-CV5M01

Management

Card

AT-CV5000Media Converter Chassis Installation Guide

4.Slide the management card into the slot, as shown in Figure 50, until the front of the card is flush with the front of the chassis.

Figure 50. Inserting the AT-CV5M01Management Card

5.Secure the AT-CV5M01Management Card to the chassis by using a Phillips screwdriver to tighten the captive screw on the management card faceplate, as shown inFigure 51.

AT-

CV5M01

PWR

RDY

FLT

 

 

LK

AT

FD

 

 

CPU RESET

243

Figure 51. Tightening the Captive Screw

Note

Always tighten the captive screw to secure the management card to the chassis. Leaving a management card partially seated may cause the CPU to halt and subsequently crash.

To reset the AT-CV5M01Management Card, perform the following procedure.

1. Locate the CPU RESET button which is recessed in the front panel of the AT-CV5M01Management Card.

77

Chapter 3: Working with Line Cards and other Modules

Note

This CPU RESET resets only the management card, and does not reset the line cards and/or the module installed in the expansion slot at the rear of the chassis. You may need to reset the management card after upgrading the firmware or after you have made a configuration change that requires resetting the module to implement the change.

Replacing an

AT-CV5M01

Management

Card

2.Press the reset button with the tip of a pen or a non-conductivepointed object, as shown inFigure 52.

AT-

 

CV5M01

PWR

 

RDY

FLT

LK

AT

FD

 

 

CPU RESET

519

Figure 52. Resetting the AT-CV5M01Management Card

When an AT-CV5M01Management Card is replaced, all the parameter settings saved on the management card are lost. To keep the current parameter settings, upload the configuration file onto a TFTP server before replacing theAT-CV5M01Management Card. After a newAT-CV5M01Management Card is installed, you can download the configuration file onto the new management card.

For instructions on how to upload and download a configuration file, refer to Chapter 10, “File Downloads and Uploads” in the AT-S70 Software Management User’s Guide.

78