Allied Telesis Converteon AT-CV5000- User Manual
Size:
5.66 Mb
Download

Chapter 2: Installation

Installing a Converteon™ Line Card

To install a Converteon™ line card, perform the following procedure:

Note

The Converteon™ line cards can be installed in any line card slots located in the front panel of the AT-CV5000chassis.

Note

For more information about the Converteon™ line cards, refer to “Converteon™ Line Cards” on page 28.

Warning: Remove all metal jewelry, such as rings and watches, before installing or removing a line card from apowered-onchassis. E26

Caution Be sure to observe all standard electrostatic discharge (ESD) precautions, such as wearing an antistatic wrist strap, to avoid damaging the device. A line card can be damaged by static electricity.

1.Remove the Converteon™ line card from its shipping package and store the package in a safe place.

Note

You must use the original package if you need to return the unit to

Allied Telesis.

2.Select the line card slot in the AT-CV5000chassis where you want to install the line card.

3.Remove the AT-CV5PNL1blank slot cover from the selected slot.

Keep the blank slot cover in a safe area in case you remove the line card. The blank slot cover is used to keep dust from getting into the chassis and maintains proper airflow, cooling, and ventilation throughout the chassis.

4.Set the line card’s DIP switches.

For more information about the DIP switch settings, refer to the

Converteon™ Media Converter Line Cards Reference Guide.

52

AT-CV5000Media Converter Chassis Installation Guide

5.Locate the top and bottom alignment guides inside the line card slots, as shown in Figure 24.

Alignment Guides

6

7

8

9

10

11

12

13

290

Alignment Guides

Figure 24. Location of the Alignment Guides

6.Align the line card with the top and bottom alignment guides located inside the slot.

7.Slide the line card into the slot, as shown in Figure 25, until the slot cover is flush with the front of the chassis.

AT-C

M202

LK AT

T

X

M

M

R

X

LK

AT

FD

 

T

X

RDY

SML ML

OAM

247

Figure 25. Inserting a Line Card

53

Chapter 2: Installation

8.Use a Phillips screwdriver to tighten the captive screw on the line card, as shown in Figure 26.

T

X

M

M

R

X

OAM

249

Figure 26. Tightening the Captive Screw

Note

Always tighten the captive screw to secure the line card to the chassis.

If you purchased an AT-CV5M01Management Card for the chassis, go to“Working with the AT-CV5M01 Management Card” on page 76. If you purchased additional line cards, repeat this procedure to install the card. Otherwise, go to“Cabling a Converteon™ Line Card in an AT-CV5000 Chassis” on page 55.

54