Allied Telesis AT-2716POE User Manual

Size:
1.8 Mb
Download

AT-2716POE

Fast Ethernet Fiber & PoE Adapter

TX

FX

ATI

Installation and Users Guide

613-001265Rev. A

Copyright ♥ 2011 Allied Telesis, Inc.

All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Telesis, Inc.

Allied Telesis and the Allied Telesis logo are trademarks of Allied Telesis, Incorporated. All other product names, company names, logos or other designations mentioned herein are trademarks or registered trademarks of their respective owners.

Allied Telesis, Inc. reserves the right to make changes in specifications and other information contained in this document without prior written notice. The information provided herein is subject to change without notice. In no event shall Allied Telesis, Inc. be liable for any incidental, special, indirect, or consequential damages whatsoever, including but not limited to lost profits, arising out of or related to this manual or the information contained herein, even if Allied Telesis, Inc. has been advised of, known, or should have known, the possibility of such damages.

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Electrical Safety and Emissions Standards

This product meets the following standards:

Federal Communications Commission Interference Statement

Declaration of Conformity

Manufacturer Name: Allied Telesis, Inc.

Declares that the product: Fast Ethernet Adapters

Model Numbers: AT-2716POE

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or television reception. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and the receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device must not cause harmful interference, and

(2)This device must accept any interference received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance.

This transmitter must not be co-locatedor operating in conjunction with any other antenna or transmitter.

IEEE802.11b or 802.11g operation of this product in the U.S.A. is firmware-limitedto channels 1 through 11.

Industry Canada

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme à la norme NMB-003du Canada.

European Union Restriction of the Use of Certain Hazardous Substances

(RoHS) in Electrical and Electronic Equipment

This Allied Telesis RoHS-compliantproduct conforms to the European Union Restriction of the Use of Certain

Hazardous Substances (RoHS) in Electrical and Electronic Equipment. Allied Telesis ensures RoHS conformance by requiring supplier Declarations of Conformity, monitoring incoming materials, and maintaining manufacturing process controls.

3

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

RFI Emissions

FCC Class A

Immunity

EN55024

Electrical Safety

EN60950-1(TUV), UL60950-1(CULUS)

Laser Safety

EN60825

Translated Safety Statements

Important: Theindicates that a translation of the safety statement is available in a PDF document titled “Translated Safety Statements” on the Allied Telesis website atwww.alliedtelesis.com/support/software. For specific instructions, see “Where to Find Management Software Updates and Product Information” on page 11.

4

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Contents

 

Preface.........................................................................................

9

Safety Symbols Used in this

 

Document.......................................................................................

10

Where to Find Management Software Updates and Product Information .............................

11

Contacting Allied Telesis .....................................................................

12

Online Support .........................................................................

12

Email and Telephone Support.............................................................

12

Returning Products......................................................................

12

For Sales Information ..................................................................

12

Warranty................................................................................

12

Chapter 1: Introduction to the AT-2716POEFast Ethernet Fiber & PoE Adapter...................

13

Functional Description ......................................................................

14

LEDs....................................................................................

15

AT-2716POEAdapter Software Drivers............................................................

16

Supported Operating Systems ............................................................

16

Software Driver Features ...............................................................

16

Chapter 2: Installing the Hardware ............................................................

17

Reviewing Safety Precautions...................................................................

18

Checking the Contents of Your Shipment.........................................................

20

Pre-InstallationChecklist ....................................................................

21

Installing a Network Adapter Card..............................................................

22

Connecting the Network Cables .................................................................

26

Checking Warranty Registration.................................................................

28

Chapter 3: Installing Windows XP NDIS Driver Software .........................................

29

Installing the NDIS DriverSoftware.............................................................

30

Using the Driver Installer .............................................................

30

Updating the Adapter Software ..........................................................

33

Uninstalling the Driver Software ..............................................................

38

Chapter 4: Installing the Windows Vista and Windows 7 NDIS Driver Software ....................

39

Installing the Driver Software.................................................................

40

Opening the Device Manager..............................................................

40

Installing AT-2716POEDriver............................................................

42

Uninstalling the Driver Software ..............................................................

44

Chapter 5: Installing the AT-2716POEVLAN CONFIGURATION Application.........................

49

Virtual LANs and the AT-2716POEVLAN CONFIGURATION Protocol ...............................

50

Installing the AT-2716POEVLAN CONFIGURATION Application ......................................

53

Configuring the VLAN and Priority settings.....................................................

56

Chapter 6: VoIP Configuration Example .........................................................

57

VoIP Support ...........................................................................

57

Chapter 7: Setting Advanced Properties ........................................................

61

Accessing the Advanced Tab ....................................................................

62

Selecting the Advanced Tab in Windows XP ...............................................

62

Selecting the Advanced Tab in Windows 7 ................................................

64

Selecting the Advanced Tab in Windows Vista ............................................

66

Modifying Advanced Properties..................................................................

69

5

 

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Contents

 

 

Updating

the 802.3az EEE property......................................................

70

Updating

the ARP Offload property......................................................

70

Updating

the EEE Control Policies property.............................................

70

Updating

the Ethernet@WireSpeed property...............................................

70

Updating

the Flow Control property.....................................................

70

Updating

the Interrupt Moderation property.............................................

71

Updating

the IPv4 Checksum Offload property............................................

71

Updating

the Jumbo MTU property........................................................

71

Updating

the Large Send Offload (IPv4) property........................................

71

Updating the Large Send Offload v2 (IPv4) property.....................................

72

Updating

the Large Send Offload v2 (IPv6) property.....................................

72

Updating

the Network Address property..................................................

72

Updating

the NS Offload property.......................................................

72

Updating

the Priority & VLAN property..................................................

72

Updating

the Receive Side Scaling property.............................................

73

Updating

the RSS Queues property.......................................................

73

Updating

the Speed & Duplex property...................................................

73

Updating

the TCP/UDP Checksum Offload (Ipv4) property..................................

73

Updating

the TCP/UDP Checksum Offload (Ipv6) property..................................

74

Updating

the Virtual Machine Queues property...........................................

74

Updating

the VLAN ID property..........................................................

74

Updating

the VMQ Lookahead Split property..............................................

74

Updating

the VMQ VLAN Filtering property...............................................

74

Updating

the Wake Up Capabilities property.............................................

75

Updating

the WOL Speed property........................................................

75

Chapter 8: Troubleshooting ...................................................................

76

Hardware Diagnostics..........................................................................

77

Checking Port LEDs on the Adapter.............................................................

78

Troubleshooting

Checklist.....................................................................

79

Testing Network

Connectivity .................................................................

80

Software Problems and Solutions...............................................................

82

Microsoft Remote Installation Service (RIS) Instructions...............................

82

Windows Operating Systems..............................................................

82

Miscellaneous..........................................................................

82

Appendix A: Specifications ...................................................................

84

Physical Specifications ......................................................................

84

Environmental Specifications..................................................................

84

Power Specifications..........................................................................

85

Performance Specifications ...................................................................

85

Operating Specifications .....................................................................

85

10/100/1000Base-TTwisted-PairPort Connectors ...............................................

85

Appendix B: Cleaning Fiber Optic Connectors ..................................................

88

Using a Cartridge-TypeCleaner ...............................................................

89

Using a Swab..................................................................................

 

91

6

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Figures

Figure 1. AT-2716POEAdapter..................................................................

14

Figure 2. AT-2716POELEDs.....................................................................

15

Figure 3. Removing

the PC Cover...............................................................

22

Figure 4. Removing

the Faceplate from PCIe Slot .............................................

23

Figure 5. Inserting the Network Adapter Card .................................................

24

Figure 6. Securing

the Adapter Card...........................................................

24

Figure 7. Installing System PS Harness connector to AT-2716POE ...............................

25

Figure 8. AT-2716POEFiber Port...............................................................

27

Figure 9. Found New Hardware Wizard - Initial Window..........................................

31

Figure 10. Found New Hardware Wizard Window: Search and Installation Options..................

32

Figure 11. Windows

XP Professional Start Window...............................................

34

Figure 12. Run Window ........................................................................

34

Figure 13. Device Manager Window (Network adapter folder is collapsed) .......................

35

Figure 14. Welcome

to Hardware Update Wizard Window ..........................................

36

Figure 15. Hardware Update Wizard Window .....................................................

36

Figure 16. Run Window ........................................................................

40

Figure 17. Windows

Device Manager Window......................................................

41

Figure 18. Device Manager Window: Ethernet Controller ........................................

42

Figure 19. Update Driver Software - Ethernet Controller Window................................

42

Figure 20. Update Driver Software: Ethernet Controller: Browse................................

43

Figure 21. Update Driver Software - Confirmation Window.......................................

43

Figure 22. Windows

7 Search Box ..............................................................

45

Figure 23. Windows

Vista Start Menu ..........................................................

46

Figure 24. Windows

Vista Run Window...........................................................

46

Figure 25. ATI VLAN Support: Welcome Screen...................................................

51

Figure 26. ATI VLAN Support: Confirm Installation Screen......................................

52

Figure 27. ATI VLAN Support: Installation Complete Screen.....................................

52

Figure 28. Welcome

to the AT-2716PoESetup Wizard Window .....................................

53

Figure 29. Confirm

Installation Window........................................................

54

Figure 30. Installing AT-2716FXTPWindow......................................................

54

Figure 31. Installation Complete Window ......................................................

55

Figure 31.1. AT-2716POEVLAN CONFIGURATION Configuration Window...............................

56

Figure 31.2. VLAN and Priority Settings Window................................................

56

Figure 32. VOIP Examples......................................................................

58

Figure 33. System Properties Dialog Box.......................................................

63

Figure 34. Windows

7 Search Box ..............................................................

64

Figure 35. Device Manager Window..............................................................

65

Figure 36. Advanced Tab ......................................................................

66

Figure 37. Windows

Vista Start Menu ..........................................................

67

Figure 38. Windows

Vista Run Window...........................................................

67

Figure 39. Advanced Tab ......................................................................

70

Figure 40. Run Command Window.................................................................

80

Figure 41. Command

Window with ipconfig/all displayed.........................................

81

Figure 42. Command

Window with ping displayed.................................................

81

Figure 43. RJ-45Connector and Port Pin Layout................................................

86

Figure 44. Ferrule

in an SC Connector Plug....................................................

88

Figure 45. Unclean

and Clean Ferrule..........................................................

88

Figure 46. Cartridge Cleaner .................................................................

89

Figure 47. Rubbing

the Ferrule Tip on the Cleaning Surface ...................................

89

Figure 48. Lint-FreeandAlcohol-FreeSwabs...................................................

91

Figure 49. Cleaning a Recessed Ferrule........................................................

91

7

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

8

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Preface

This guide contains instructions on how to install the AT-2716POEFast Ethernet Fiber & PoE Adapter. Procedures that describe how to install and configure the driver software on the Windows XP, Windows Vista, and Windows 7 Operating Systems are provided.

The Preface contains the following sections:

“Safety Symbols Used in this Document” on page 10

“Where to Find Management Software Updates and Product Information” on page 11

“Contacting Allied Telesis” on page 12

9

AT-2716POEFast Ethernet Fiber & PoE Adapter Installation and User’s Guide

Safety Symbols Used in this Document

This document uses the safety symbols defined in Table 1.

Table 1. Safety Symbols

Symbol

Meaning

Description

 

Caution

Performing or omitting a specific action may

 

 

result in equipment damage or loss of data.

 

Warning

Performing or omitting a specific action may

 

 

result in electrical shock.

10