Alliance Laundry Systems 504523R3 User Manual

Size:
1.68 Mb
Download

Metered and

Nonmetered

Commercial Single

Dryers

(Electric and Gas Models)

REMARQUE: Le guide est rédigé en anglais et en français. La version française figure à la suite de la version anglaise.

KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE. (If the dryer changes ownership, be sure this manual accompanies the dryer.)

Operation and Installation

Part No. 504523R3

November 1998

WARNING

FOR YOUR SAFETY, the information in this manual must be followed to minimize the

risk of fire or explosion or to prevent property damage, personal injury or death.

W033

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

WHAT TO DO IF YOU SMELL GAS:

Do not try to light any appliance.

Do not touch any electrical switch; do not use any phone in your building.

Clear the room, building or area of all occupants.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

Installation and service must be performed by a qualified installer, service agency or the gas supplier.

FOR YOUR SAFETY

Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

IMPORTANT: Purchaser must consult the local gas supplier for suggested instructions to be followed if the dryer user smells gas. The gas utility instructions plus the SAFETY and WARNING note directly above must be posted in a prominent location near the dryer for customer use.

Electric models are not approved by the Canadian Gas Association.

504523

1

Table of

Contents

Replacement Parts ...............................................................................

3

Important Safety Instructions .............................................................

4

Roughing In Dimensions .....................................................................

6

Meter Case ............................................................................................

8

Timer Cams ..........................................................................................

8

Dryer Slide Extension ..........................................................................

9

Before You Start

 

Tools ..............................................................................................

10

Exhaust ...........................................................................................

10

Electrical.........................................................................................

10

Gas ..................................................................................................

10

Location ..........................................................................................

10

Installing the Dryer

 

STEP 1 (Position and Level the Dryer) .........................................

11

STEP 2 (Connect Dryer Exhaust System)......................................

11

STEP 3 (Connect Gas Supply Pipe) ...............................................

12

STEP 4 (Wipe Out Inside of Dryer) ...............................................

13

STEP 5 (Plug in the Dryer) ............................................................

13

STEP 6 (Check Installation) ...........................................................

13

Heat Source Check .............................................................................

14

Reversing Door Procedure ................................................................

15

Electrical Requirements (Electric Dryers) .......................................

16

Electrical Requirements (Gas Dryers) .............................................

17

Gas Requirements .............................................................................

19

Location Requirements .....................................................................

20

Dryer Exhaust Requirements

 

Exhaust System Materials ..............................................................

21

Make Up Air Requirements............................................................

22

Exhaust System ..............................................................................

22

Exhaust Direction ...........................................................................

22

Exhaust System Maintenance.........................................................

23

Dryer Airflow .................................................................................

23

Reduced Clearance Elbow..............................................................

23

Multi-DryerInstallation Exhaust Requirements............................

24

Manufactured (Mobile) Home Installation ......................................

27

Lint Filter ............................................................................................

28

Motor OverLoad Protector ...............................................................

28

User-MaintenanceInstructions

 

Lubrication .....................................................................................

29

Care of Your Dryer .........................................................................

29

Exhaust System ..............................................................................

29

For Energy Conservation ..................................................................

29

Before You Call for Service ...............................................................

30

Additional Dryer Security .................................................................

31

Operation Instructions for Electromechanical Dryers ...................

32

Operation Instructions for Electronic Control Dryers ...................

34

Information for Handy Reference ....................................................

37

Installer Check ....................................................................

Back Cover

©Copyright 1998, Alliance Laundry Systems LLC

All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed written consent of the publisher.

2

504523

Replacement Parts . . .

If replacement parts are required, contact the source where you purchased your dryer, or contact

Alliance Laundry Systems LLC

Shepard Street

P.O. Box 990

Ripon, WI 54971-0990

Phone: (920) 748-3950

for the name and address of the nearest authorized parts distributor.

504523

3

IMPORTANT SAFETY INSTRUCTIONS

(SAVE THESE INSTRUCTIONS)

WARNING

To reduce the risk of fire, electric shock, or injury to persons when using your dryer, follow these basic precautions:

W034

1.Read all instructions before using the dryer.

2.Refer to the GROUNDING INSTRUCTIONS in the INSTALLATION manual for the proper grounding of the dryer.

3.Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry-cleaningsolvents, other flammable or explosive substances as they give off vapors that could ignite or explode.

4.Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children. This is a safety rule for all appliances.

5.Before the dryer is removed from service or discarded, remove the door to the drying compartment.

6.Do not reach into the dryer if the cylinder is revolving.

7.Do not install or store the dryer where it will be exposed to water and/or weather.

8.Do not tamper with the controls.

9.Do not repair or replace any part of the dryer, or attempt any servicing unless specifically recommended in the user-maintenanceinstructions or in publisheduser-repairinstructions that you understand and have the skills to carry out.

10.Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.

11.To reduce the risk of fire, DO NOT DRY plastics or articles containing foam rubber or similarly textured rubberlike materials.

12.ALWAYS clean the lint filter after every load. A layer of lint in the filter reduces drying efficiency and prolongs drying time.

13.Keep area around the exhaust opening and adjacent surrounding area free from the accumulation of lint, dust and dirt.

14.The interior of the dryer and the exhaust duct should be cleaned periodically by qualified service personnel.

15.If not installed, operated and maintained in accordance with the manufacturer’s instructions or if there is damage to or mishandling of this product’s components, use of this product could expose you to substances in the fuel or from fuel combustion which can cause death or serious illness and which are known to the State of California to cause cancer, birth defects or other reproductive harm.

16.Dryer will not operate with the loading door open. DO NOT by-passthe door safety switch by permitting the dryer to operate with the door open. The dryer will stop tumbling when the door is opened. Do not use the dryer if it does not stop tumbling when the door is opened or starts tumbling without pressing the START mechanism. Remove the dryer from use and call the service person.

17.Do not put articles soiled with vegetable or cooking oil in the dryer, as these oils may not be removed during washing. Due to the remaining oil, the fabric may catch on fire by itself.

18.To reduce the risk of fire, DO NOT put clothes which have traces of any flammable substances such as machine oil, flammable chemicals, thinner, etc., or anything containing wax or chemicals such as in mops and cleaning cloths, or anything dry-cleanedat home with a drycleaning solvent in the dryer.

19.Use the dryer only for its intended purpose, drying clothes.

20.Always disconnect the electrical power to the dryer before attempting service. Disconnect the power cord by grasping the plug, not the cord.

21.Replace worn power cords and/or loose plugs.

22.Install this dryer according to the INSTALLATION INSTRUCTIONS. All connections for electrical power, grounding and gas supply must comply with local codes and be made by licensed personnel when required. Do not do it yourself unless you know how!

23.Remove laundry immediately after the dryer stops.

4

504523

24.Always read and follow manufacturer’s instructions on packages of laundry and cleaning aids. Heed all warnings or precautions. To reduce the risk of poisoning or chemical burns, keep them out of reach of children at all times (preferably in a locked cabinet).

25.Do not tumble fiber glass curtains and draperies unless the label says it can be done. If they are dried, wipe out the cylinder with a damp cloth to remove particles of fiber glass.

26.ALWAYS follow the fabric care instructions supplied by the garment manufacturer.

27.Never operate the dryer with any guards and/or panels removed.

28.DO NOT operate the dryer with missing or broken parts.

29.DO NOT by-passany safety devices.

30.Failure to install, maintain, and/or operate this machine according to the manufacturer’s instructions may result in conditions which can produce bodily injury and/or property damage.

IMPORTANT: Solvent vapors from dry-cleaningmachines create acids when drawn through the heater of the drying unit. These acids are corrosive to the dryer as well as to the laundry load being dried. Be suremake-upair is free of solvent vapors.

IMPORTANT: Have your dryer installed properly. Don’t do it yourself unless you know how!

NOTE: The WARNING and IMPORTANT SAFETY INSTRUCTIONS appearing in this manual are not meant to cover all possible conditions and situations that may occur. Common sense, caution and care must be exercised when installing, maintaining, or operating the dryer.

Always contact your dealer, distributor, service agent or the manufacturer about any problems or conditions you do not understand.

504523

5

Roughing In Dimensions . . .

(Metered Models)

 

 

 

(36")

cm (43.2")

 

 

10.2 cm

*91.4cm

*109.7

 

 

 

10.2 cm

 

 

(4.0")

 

(4.0")

 

19.6 cm

 

 

39.1 cm

 

(7.7")

 

 

 

 

 

(15.4")

 

 

1.0 cm

 

59.7 cm

71.1 cm

 

 

(.4")

 

68.3 cm

(23.5")

(28")

 

 

(26.9")

* WITH LEVELING LEGS TURNED INTO BASE.

 

 

D329IE3F

 

ELECTRIC MODELS

 

 

 

(36")

cm (43.2")

 

 

 

10.2 cm

*91.4cm

*109.7

 

 

 

 

10.2 cm

 

 

 

(4.0")

 

(4.0")

6 cm

 

 

 

 

 

 

 

 

 

 

(2.3")

 

 

 

 

 

7 cm

 

 

 

 

 

(2.8")

 

19.6 cm

 

 

39.1 cm

3/8"

 

(7.7")

1.0 cm

(15.4")

 

NPT GAS

 

 

 

59.7 cm

71.1 cm

(.4")

 

68.3 cm

CONNECTION

(23.5")

(28")

 

 

(26.9")

 

* WITH LEVELING LEGS TURNED INTO BASE.

 

 

 

D330IE3F

 

 

GAS MODELS

 

NOTE: Side, rear and bottom exhaust openings are 10.2 cm (four inch) ducting. Gas models cannot be vented out left side of cabinet because of burner housing.

IMPORTANT: The dryer should have sufficient clearance around it for needed ventilation and for the ease of installation and servicing. For maximum drying performance, we recommend that more clearance be allowed around the dryer than the clearances that are listed throughout this manual.

6

504523

Roughing In Dimensions . . .

(Nonmetered Models)

 

 

10.2 cm

*91.4 cm (36")

*109.7 cm (43.2")

10.2 cm

 

 

(4.0")

 

 

(4.0")

 

 

 

 

 

 

19.6 cm

 

 

 

39.1 cm

 

(7.7")

1.0 cm

 

 

(15.4")

59.7 cm

71.1 cm

 

 

68.3 cm

(.4")

 

 

(23.5")

(28")

 

 

(26.9")

 

 

 

* WITH LEVELING LEGS TURNED INTO BASE.

 

 

 

D331IE3D

 

 

 

 

 

 

ELECTRIC MODELS

 

 

 

 

(36")

cm (43.2")

 

 

 

10.2 cm

*91.4 cm

*109.7

 

 

 

 

 

 

 

 

(4.0")

 

 

6 cm

 

 

 

 

 

 

 

 

 

 

(2.3")

 

 

 

 

 

10.2 cm

 

19.6 cm

 

 

39.1 cm

(4.0")

 

 

 

 

 

(7.7")

 

 

3/8"

 

 

 

(15.4")

 

 

 

 

NPT GAS

59.7 cm

71.1 cm

1.0 cm

68.3 cm

CONNECTION

(23.5")

(28")

(.4")

(26.9")

 

* WITH LEVELING LEGS TURNED INTO BASE.

 

 

D332IE3D

 

 

GAS MODELS

 

NOTE: Side, rear and bottom exhaust openings are 10.2 cm (four inch) ducting. Gas models cannot be vented out left side of cabinet because of burner housing.

IMPORTANT: The dryer should have sufficient clearance around it for needed ventilation and for the ease of installation and servicing. For maximum drying performance, we recommend that more clearance be allowed around the dryer than the clearances that are listed throughout this manual.

504523

7

Meter Case . . .

(Metered Models)

The factory mounted coin meter case does not include the service door lock, coin drawer, coin drawer lock and keys. These parts must be ordered (at extra cost) according to the purchaser’s requirements direct from the manufacturer of your choice.

NOTE: You have the option of using a screw type lock or a 1/4 turn lock on the meter case service door. If you choose to use a screw lock, then the special bracket (located inside the meter case) must be used. DO NOT use the special bracket if a 1/4 turn lock is used.

Coin Drawer Security — for additional security, drill out the two pilot holes on each front side of the meter case to 1/4 or 5/16 inch (6.4 or 8.0 mm) holes and install a bicycle lock through these holes.

Timer Cams . . .

(Metered Models)

The dryer timer is factory equipped with a 45 minute timing cam. If this drying time is not suitable to your

installation, the following cams can be found in the envelope located in the cylinder:

Electric Dryers

Gas Dryers

1-53242Cams (30 Minutes)

1-53242Cams (30 Minutes)

1-53240Cams (60 Minutes)

 

A 60 minute timing cam, Part No. 53240, is available for gas dryers as optional equipment at extra cost.

8

504523