Alcatel-Lucent 6850-P24L User Manual
Size:
1.45 Mb
Download

Booting OmniSwitch 6850

Series Switches

Booting a Standalone Switch

The OmniSwitch 6850 Series switch does not use an on/off switch. The power cord is the switch’s only connect/disconnect device. The power connector socket is located on the switch’s rear panel. For more information, refer to the

OmniSwitch 6850 Series Hardware Users Guide.

To boot the switch, plug the power cord (provided) into the power connector socket at the switch’s rear panel. Next, plug the power cord into an easily-accessiblepower source, such as a grounded AC outlet or an Uninterruptible Power Supply (UPS).

The switch immediately begins the boot process. Allow a few moments for the switch to boot completely, then verify the status of all LEDs on the switch’s front panel. A successful boot for a standalone switch displays the following LED states:

LED States for a Standalone Switch

OK

Solid green

 

 

PRI

Solid green

 

 

PWR

Solid green

 

 

LED States for a Standalone Switch

BPS

Solid amber, if BPS attached is failed;

 

off, if no operational BPS is attached;

 

solid green if an operational BPS is

 

attached and operating normally.

 

 

XFP1

Off (applies to all OmniSwitch 6850

 

Series switches except for the

 

OmniSwitch 6850-24X,

 

OmniSwitch 6850-P24X,

 

OmniSwitch 6850-48X,

 

OmniSwitch 6850-P48X,and

 

OmniSwitch 6850-U24X).

 

 

XFP2

Off (applies to all OmniSwitch 6850

 

Series switches except for the

 

OmniSwitch 6850-24X,

 

OmniSwitch 6850-P24X,

 

OmniSwitch 6850-48X,

 

OmniSwitch 6850-P48X,and

 

OmniSwitch 6850-U24X).

 

 

Slot Indicator

1–8(non-blinking),depending on the

 

slot number value in the boot.slot.cfg

 

file. See the OmniSwitch 6850 Series

 

Hardware Users Guide for detailed

 

information. The default value is 1.

 

 

12 Booting OmniSwitch 6850 Series Switches

June 2007

If any of the LED state differs from the states shown in the table above, refer to the OmniSwitch 6850 Series Hardware Users Guide for more information. ContactAlcatel-LucentCustomer Support if the unexpected LED state persists.

For information on booting stacked configurations and dynamic slot numbering, refer to the OmniSwitch 6850 Series Hardware Users Guide.

June 2007

Booting OmniSwitch 6850 Series Switches 13