Aiwa CDC-X145 User Manual

0 (0)
COMPACT
DIGITAL AUDIO
OPERATING INSTRUCTIONS
MANUAL DE INSTRUCCIONES
MODE D’EMPLOI
CDC-X145
YU
STEREO CAR CD RECEIVER
AUTOMOVIL
OWNER’S RECORD
For your convenience, record the model number and
serial number (you will find them on the right side of
your set) in the space provided below. Please refer to
them when you contact your AIWA dealer in case of
difficulty.
Model No. |CDC-X145 |
Serial No. I I
Welcome
Thank you for your purchasing this AIWA product.
To optimize the performance of this unit, please
read through this manual carefully.
In addition to this operating instructions manual,
be sure to refer to the separate installation and
connections manuals as well.

PRECAUTIONS

__________
This unit is designed to be operated on a 12-volt
DC negative-ground electrical system only.
♦To prevent short-circuiting, disconnect the
negative car battery terminal until the unit has
been mounted and connected completely.
When replacing the fuse, be sure to use one
whose amperage rating is identical. Use of a
fuse of higher amperage may cause serious
damage to the unit.
• Do NOT attempt to disassemble this unit. Laser
rays from the optical pickup are dangerous to
the eyes.
Make sure that pins or other foreign objects do
not get inside the unit; they may cause
malfunctioning, or a safety hazard such as
electrical shock or exposure of laser rays.
When your car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the unit to cool off before
operating it.
Keep the volume at such a level that you can
hear outside warning sounds (horns, sirens,
etc.).
NOTE
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates, uses, andean radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no guarantee
that Interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the equipment off
and on, the user is encouraged to try to correct
the interference by one or more of the following
measures;
— Reorient or relocate the receiving antenna.
Increase the separation between the
equipment and receiver.
— Connect the equipment into an outlet on
circuit different from that to which the receiver
is connected.
— Consult the dealer or an experienced radio/
TV technician for help.
CAUTION
Modifications or adjustments to this product, which
are not expressly approved by the manufacturer,
may void the user’s right or authority to operate
this product.
1 ENGLISH

TABLE OF CONTENTS

FRONT PANEL..........................................................................................................................3
DETACHING AND ATTACHING THE FRONT PANEL
............................................................
4
SETTING THE CLOCK..............................................................................................................5
RADIO OPERATION.................................................................................................................5
PRESETTING STATIONS.........................................................................................................6
CD PLAY....................................................................................................................................8
SOUND ADJUSTMENTS..........................................................................................................9
CONNECTING A PORTABLE CASSETTE PLAYER OR OTHER EQUIPMENT
..................
10
TROUBLE SHOOTING.............................................................................................................11
MAINTENANCE........................................................................................................................11
SPECIFICATIONS...................................................................................................................12
Notes on CDs
•A defective or soiled disc inserted into the unit
can cause sound to drop out during playback.
♦ Handle the disc by holding its inner and outer
edges.
• Clean the disc before playback. Wipe the disc
from the center outward with a cleaning cloth.
• Do NOT touch the surface of the unlabeled side
of the disc.
Do NOTsliok paper or tape etc. on the surface.
• Do NOT expose the disc to direct sunlight or
excessive heat.
NEVER use solvents such as benzine or alcohol
to clean the disc.
Smaller 3-inch (8cm) CDs can not be played on
this unit. And do not use adaptor as it may cause
malfunctioning.
Do not use irregular shape CDs (example: heart
shaped, octagonal ones). It may result in
malfunction.
ENGLISH 2

FRONT PANEL

Display window
® PWR (power on/off) button
® SEL (select) button
(D VOL (volume/audio) control
® Disc compartment
©TAPE button
© DISP (display) button
® ± (eject) button
©MUTE button
© ►« (forward skip)/TUNEyv/
(back skip)/TUNE\/' buttons
® LOUD button
®TAPE IN jack (3.5-mm dia.)
©REPEAT button
© Preset station buttons 1-6
© CD (CD play/pause) button
© BAND button
© A.ME (auto memory/preset scan) button
© iL (release) button
© CD indicator
© Band indicator
© REPEAT indicator
©TRE (treble) indicator
©Audio control indications
© BAL (balance) indicator
© FAD (fader) indicator
©TAPE indicator
©Track/Preset number indication
© VOL (volume) indicator
©AM/PM indicator
© BAS (bass) indicator
© Main display section
© LOCAL Indicator
© STEREO indicator
©LOUD (loudness) indicator
© MUTE indicator
3 ENGLISH
DETACHING AND
ATTACHING THE FRONT
PANEL
Attaching the front panel
You can detach the front panel from the unit and
carry it with you when you leave your car
unattended.
When you carry the front panel out of your car,
use the supplied carring case.
Before detaching the front panel, remove the CD
to prevent possible damage to the unit.
1 Press PWR to turn the unit off.
2 While supporting the front panel with
one hand, press £ to release one side
of the panel. Care must be taken not to
drop the panel. It may suddenly eject at
this point.
3 When the front panel is lifted from the
unit, remove it by pulling away from the
unit.
Do NOT touch the connector on the reverse
side of the front panel, as doing so may
contaminate the connector and cause a poor
connection resulting in a malfunction.
Security Lamp
When the front panel Is detached, you can find an
LED lamp on the front side of the unit. This lamp
is designed to deter theft, and continues to flash
when the car’s Ignition is turned off with the front
panel detached. This unit is not equipped with
any other security systems such as a security
alarm, so there are limitations to its effectiveness.
LED lamp
emusH 4
Loading...
+ 11 hidden pages