Aiwa CDC-X135 User Manual

Size:
865.85 Kb
Download

CDC-X135w

CDC-XI15w

STEREO CAR CO RECEIVER RAD1O-TOCADISCOSDECD ESTEREOFONICOPARA AUTOIMOVIL

OWNER’S RECORD

For your convenience, record the model number and serial number (you will find them ontheright side of your$et) inthespace provided below. Please referto them when you contact your AIWA dealer in case of difficulty.

Model No. ICDC-X135,CDC-X115

I

 

‘eria’ ‘0 ~

 

Welcome

Thank you foryour purchasing this AIWAproduct. To optimize the performance of this unit, please read through this manual carefully.

In addition to this operating instructions manual, be sure to refer to the separate installation and connections manuals as well.

PRECAUTIONS

This unit is designed to be operated on a 12-voltDCnegative-groundelectrical system only.

To prevent short-circuiting,disconnect the negative car battery terminal until the unit has been mounted and connected completely,

When replacing the fuse, be sure to use one whose amperage rating is identical. Use of a fuse of higher amperage may cause serious damage to the unit.

Do NOT attempt to disassemble this unit. Laser rays from the optical pickup are dangerous to the eyes.

Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctioning, or a safety hazard such as electrical shock or exposure of laser rays.

When your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it.

Keep the volume at such a level that you can hear outside warning sounds (horns, sirens, etc.).

NOTE

This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee thai interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

— Reorient or relocate the receiving antenna, —Increasethe separation between the

equipment and receiver.

—Connectthe equipment into an outlet on circuit different from that to which the receiver ie connected.

Consult the dealer or an experienced radio/ TV technician for help.

CAUTION

Modificafionsoradjustments to this product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

i ENGLISH

TABLE OF CONTENTS

 

FRONT PANEL ...................................................................................................................................

3

DETACHING AND AITACHING THE FRONT PANEL ......................................................................

4

SETTING THE CLOCK ......................................................................................................................

5

RADIO OPERATION .........................................................................................................................

, 5

PRESETTING STATIONS ..................................................................................................................

6

CD PLAY ....................................................................................................................................... ......

8

SOUND ADJUSTMENTS ...................................................................................................................

9

CONNECTING A PORTABLE CASSETTE PLAYER OR OTHER EQUIPMENT .............................

10

TROUBLE SHOOTING .....................................................................................................................

11

MAINTENANCE .........................................................................................................................

11

SPECIFICATIONS ............................................................................................................................

12

Notes on CDs

A defective or soiled disc inserted into the unit can cause sound to drop out during playback.

Handle the disc by holding its inner and outer edges,

. Clean the dtsc before playback. Wipe the disc from the center outward with a cleaning cloth.

Do NOT touch the surface of the unlabeled side of the disc,

Do NOTstick paper or tape etc. on the surface.

Do NOT expose the disc to direct sunlight or excessive heat.

NEVER use solvents such as benzine or alcohol

to clean the disc.

. smaller 3.inch (8cm) CDs can not be played on this unit. And do not use adaptor as it may cause malfunctioning.

Do not use irregular shape CDs (example: heartshaped, octagonal ones). h may remrlt in malfunction.

ENGLISH 2

FRONTPANEL

Display window

??

??

?

??

@PWR bower onloff) button

@SEL (select) button

@VOL (volume/audio) control

@Disc compartment @TAPE button

@DISP (dlsplsy) button

@4 (eject) button

@MUTE button

@W (forward skip)/TUNE/V

W (back skip)/TUNEV buttons

@LOUD button

@TAPE IN jack (3.5-mmdia.) @REPEAT button

@Preset station buttons 1-6@CD (CD playlpauae) button @BAND button

@A.ME (auto memory/preset scan) button

@* (release) button

@CD indicator @Band indicator @REPEAT indicator

@TRE (treble) indicator @Audio control indications @ BAL (balance) Indicator @FAD (fader) indicator @TAPE indicator

@TracldPreset number indication @VOL (volume) indicator @AM/PM indicator

@l BAS (baes) indicator @IMain display section @LOCAL indicator @STEREO indicator @LOUD (loudness) indicator @ MUTE indicator

3 ENGLISH

DETACHING AND

ATTACHING THE FRONT

PANEL

2

You can detach the front panel from the unit and carry it with you when you leave your car unattended.

When you carry the front panel out of your car, use the supplied earring case.

Before detaching the front panel, remove the CD to prevent possible damage to the unit.

Press PWR to turn the unit off.

While supporting the front panel with one hand, press I?Ito release one side of the panel, Care must be taken not to drop the panel. It may suddenly eject at this point.

When the front panel is lifted from the unit, remove it by pulling away from the unit.

0

Do NOT touch the connector on the reverse side of the front panel, as doing so may contaminate the connector and cause a poor connection resulting in a malfunction.

Attaching the front panel

Security Lamp

When the front panel is detached, you can find an LED lamp on the front side of the unit. This lamp is designed to deter theft, and continues to flash when the car’s ignition is turned off with the front panel detached. This unit is not equipped with any other security systems such as a security alarm, so there are limitations to its effectiveness.

ENGLISH 4

SETTING THE CLOCK

1

2,4

3

1Press PWR to turn the unit on.

2Press and hold DISP for more than 2 seconds.

5 Press Atoset thehour. Press V to set the minutes.

4Presa DISP.

The clock starts working from Osecond.

Having the clock displayedwhile the unit is turned on

Pre$s DISP. The clock display appears for a few minutes, then the unit rsturnsto its former cfkplay.

RADIO OPERATION

2

1 Press PWR to turn the unit on.

2Press BAND to sefect the band from among FM1, FM2, FM3, AMI, and AM2.

The band indication appears cyclically in ordsr.

FM1, FM2and FM3sharethesamefrequency range.

AM1 and AM2 share the same frequsncy range.

Bandin&ation Frequencyindication

3Press (more than 0.5 second) either TUNE A or TUNE V to tune in the desired station.

Press A to increase and V to decrease the frequency.

The unit starts scanning and tunes in a station automatically (Seek tuning).

Press the button again to deactivate the function. Repeat the procedure until the desired station is tuned in.

Note

If you press (less than 0.5 second at a time) either TUNE A or TUNE V, the frequency decreases or increases step by step.

4Press VOL to project out the control and turn it to + or - to adjust the volume,

5 ENGLISH

To turn the unit off

Press PWR.

Note

PRESETTING STATIONS

1

23

1 Press PWR to turn the unit on.

2Press BAND to sefect a desired band from among FM1, FM2, FM3, AM1, and AM2.

~

3Prees snd hold A.ME for more than 2 seconds to activate the automatic presetting function.

This unit can store up to 6 stations in memory for preset station button 1 to 6 with LOCAL indicator lights up.

If the unit could not search for all of 6 stations, LOCAL indicator goes off and starts searching for weaker stations again.

Use this function to automatically preset up to 6 stations each for FM1, FM2, FM3, AM1, and AM2 (up to a total of 30 stations).

When auto memory is completed, the preset stations are automatically scanned in order.

To stop auto memory, press A.ME again.

To check the preset stations (preset scan)

If you wish to check the preset stations, press A.ME forlessthan 2seconds. The preset stations stored in memory will be tuned in for 5 seconds each in order.

To stop this function, press A.ME again or press any of the preset station buttons 1 to 6.

ENGLISH 6

PRESETTING STATIONS

2

1

3

42

1 Press PWR to turn the unit on.

2Press BAND to select the band from among FM1, FM2, FM3, AM1, and AM2.

3Tune in the station that you wish to preset with TUNE A or TUNE V.

4Press one of the preset station buttons 1 to 6 for approximately 2 seconds.

While the station you are presetting is being registered in memory, the sound is momentarily muted.

The number of the pressed preset station button appears next to the frequency indication.

Repeat these procedures to preset up to 6 stations each for FM1, FM2, FM3, AM1, and AM2.

You can manually preset stations that have not been selected by auto memory.

If you try to preset a station on a preset station button on which another station of the same band has already been preset, the previously preset station will be erased.

32

1Press PWR to turn the unit on.

2Press BAND to select a desired band from among FM1, FM2, FM3, AMI, and AM2.

3Prassthedesired preset station button.

The number of the pressed preset station button appears next to the frequency indication.

Active tuning reception control (ATRC)

This unit automatically suppresses FM noise causad by varying signal strength resulting from movement of the car.

The built-inautomatic blendtng circuit mixes the left and right channel signals according to the strength of the reception. At the same time, thehigh-cutcircuit activates to maintain the sound quality.

If the reception becomes even weaker, the unit automatically switches to Monaural mode to reduce noise.

7 ENGLISH

CD PLAY

,

2 1

1Insert a disc with the labeled aide upward to start CD play.

If a disc is already inserted, press PWR to start CD play.

The !rack number and elapsed playing time appear.

CDiindicator

1

I

Tracknumber Elapsedplayingtime

2Press VOL to project out the control and turn it to + or - to adjuat the volume.

AD’M

REPEAT 1+

Press these buttons to operate CD play.

Press To

&Eject a disc.

CD Pause play.

The track number and elapsed playing time flash.

To resume play, press CD again.

wSkip to the next track with a short press (for less than 0.5 seconds).

Each extra press skips forward one extra track.

To search forward rapidly, press and hold W down until the desired part is played, then release it.

144Restart the track currently in play with a short press (for less than 0.5 seconds). Each extra press skips backward one extra track.

To search backwerd rapidly, press and hold 144 down until the desired part is daved, then release it.

The A button is active only in CD mode.

Smaller 3-inch(8 cm) CDs can not be played on this unit. And do not use an adaptor as it may cause malfunctioning.

The CD play starts from the first track on the disc.

ENGLISH 8

CD PLA Y

Press REPEAT during CD play. The’’REPEAT’indicator lights up andthecurrently selected track is played repeatedly.

Press REPEAT again to deactivate Repeat play.

Note

If Repeat play is not activated, all the tracks on the disc are played repeatedly.

SOUNDADJUSTMENTS

123

MU,TE

LOUD

1Press PWR to turn the unit on.

2Press SEL to select the mode that you wish toadjustfrom: VOL(volume), BAS (bass), TRE(treble), BAL(balance), FAD (fader).

The following indications appear in cyclic order.

r+ m“m”m”(ZZl!l”4ZIZ1

---l

The selected mode switches to Voiume mode if you do not proceed with step 2 within 9 seconds.

3Press VOL to project out the control and turn it to +-or- to adjust the level.

Turn and hold the control to change the level rapidly.

Adjust each mode referring to the audio control indications in the display window.

 

 

+

 

Decreases the

I Increases the

 

volume level

volume level

Em

Decreases the

I Increases the

bass level

bass level

 

~Decreases the

I Increases the

 

treble level

] treble level

 

I Decreases the

I Decreases the

Without selecting any mode with SEL, only the volume level can be adjusted by turning VOL.

9 ENGLISH