Aiwa CDC-X116 User Manual

Size:
2.41 Mb
Download

~~gAA

DIGITAL AUDIO

CDC”XI16Y“

STEREO CAR CD RECEIVER

RADIO-TOCADISCOSDE CD ESTEREOFONICO PARA AUTOMOVIL

OWNER’S RECORD

For your convenience, record the model number and serial number (you will find them on the right side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty.

Model

No. ]CDC-X116

1

 

 

Serial

No. ~

 

 

I

I

Welcome

Thank you for your purchasing thisAIWA product. To optimize the performance of this unit, please read through this manual carefully.

In addition to this operating instructions manual, be sure to refer to the separate installation and connections manuals as well.

PRECAUTIONS

This unit is designed to be operated on a 12-voltDCnegative-groundelectrical system only.

To prevent short-circuiting,disconnect the negative car battery terminal until the unit has been mounted and connected completely.

When replacing the fuse, be sure to use one whose amperage rating is identical. Use of a fuse of higher amperage may cause serious damage to the unit.

Do NOT attempt to disassemble this unit. Laser rays from the optical pickup are dangerous to the eyes.

Make sure that pins or other foreign objects do not get inside the unit; they may cause malfunctioning, or a safety hazard such as

electrical shock or exposure of laser rays.

. When your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it.

Keep the volume at such a level that you can hear outside warning sounds (horns, sirens, etc.).

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/ TV technician for help.

CAUTION

Modifications oradjustmentstothis product, which are not expressly approved by the manufacturer, may void the user’s right or authority to operate this product.

1 ENGLISH

TABLE OF CONTENTS

 

 

FRONT PANEL ...................................................................................................................................

 

 

3

DETACHING

AND AITACHING

THE FRONT

PANEL ......................................................................

4

SETTING THE CLOCK .......................................................................................................................

 

 

5

RADIO OPERATION ..........................................................................................................................

 

 

5

PRESETTING

STATIONS ..................................................................................................................

 

 

6

MY INFORMATION SWITCH .............................................................................................................

 

 

8

CD PLAY .............................................................................................................................................

 

 

 

9

SOUND ADJUSTMENTS .................................................................................................................

 

 

11

CONNECTING

A PORTABLE

CASSETTE/MD

PLAYER OR OTHER EQUIPMENT ......................

12

TROUBLESHOOTING ......................................................................................................................

 

 

12

MAINTENANCE ................................................................................................................................

 

 

13

SPECIFICATIONS ............................................................................................................................

 

 

13

Noteson CDs

Adefective orsoiled disc inserted into the unit can cause sound to drop out during playback.

Handle the disc by holding its inner and outer edges.

Do NOT touch the surface of the unlabeled side of the disc.

Do NOTstick paper or tape etc. on the surface.

Do NOT expose the disc to dkect sunlight or excessive heat.

Clean the disc before playback. Wipe the disc from the center outward with a cleaning cloth.

.

NEVER usesolvents suchasbenzine oralcohol = to clean the disc.

Smaller 3-inch(8cm) CDs cannot be played on this unit. And do not use an adaptor as it may cause malfunctioning.

Do NOT use irregular shape CDs (example: heart-shaped,octagonal ones). It may result in malfunction,

ENGLISH 2

FRONTPANEL

Eii9isi1234. 5 6 78910??

Displaywindow

o39

@+/– (audio control) button

@PWR (power otioff) button

@SEL (select) button

@H.BASS button

@Disc compsrtmsnt @BAND bunon

@A (eject) button

@~ (release) button

@A.ME (auto memory/presetSCWt) fXtttOtI

@TUNE 71A buttons @TAPE/MD IN jack(3.5-mmdia.) @ MUTE button

@Preset station buttons 1-6

@W (back skip) button

@bPf (forward skip) button @IINT (intro) button

@REP1 (repeat 1) button

@RANDOM button

@CD (CD play/pause) button @ DISP (display) button

@MY INFO (my information) button @TAPEhID IN button

@SCAN indicator

@RANDOM indicator @JTAPE indicator @REPEAT indicator

@VOL (volume) indicator @lBAS (bass) indicator

@TRE (treble) indicator

@BAL (balance) indicator

@FAD (fader) indicator

@MY INFO (my information) indicator @Audio control indications

@H BASS indicator @CD indicator (?$Band indicator

@TracWPreset number indication

@AWPM indicator

@Main display section

@LO (local) indicator @ST (stereo) indicator

3 ENGLISH

DETACHING AND

ATTACHING THE FRONT

PANEL

Attaching the front panel

/

kd

You can detach the front panel from the unit and carry it with you when you leave your car unattended.

When you carty the front panel out of your car, use the supplied carrying case.

Before detaching the front panel, remove the disc to prevent possible damage to thle unit.

1 Press PWR to turn the unit off.

2While supporting the front panelwith one hand, press I?Ito rele!ase one side of the panel. Care must be taken not to drop the panel. It may sudldenlyeject at this point.

3When the front panel is Wted from the unit, remove it by pulling away from the unit.

Do NOT touch the connector on the reverse side of the front panel, as doing so may contaminate the connector and cause a poor connection resulting in a malfunction.

Security Lamp

When the front panel is detached, you can find an LED lamp on the front side of the unit. This lamp is designed to deter theft, and continues to flash when the front panel is detached. This unit is not equipped with any other security systems such as a securiw alarm, so there are limitations to its effectiveness.

LED’lamp

ENGLISH 4

SETTING THE CLOCK

1 3

2,4

I Press PWR to turn the unit on.

zPress and hold DISP for more than 2 seconds.

s Press TUNE 7 to set the hour. Press TUNE A to eet the minute.

4Press DISP.

The clock starts working from O second.

Having the clock displayed while the unit is

turned on

Press DISP. To return the unit to its former display, press DISP again,

RADIO OPERATION

1 2

4 3

1 Press PWR to turn the unit on.

2Press BAND to select the band from among FM1, FM2, FM3, AM1, and AM2.

The band indicators appear cyclically in order.

FM1, FM2 and FM3 share the same frequency range.

AM1 and AM2 share the same frequency range.

Band indicator Frequency indication

3Press (more than 2 seconds) either TUNE YorTUNE Atotune inthedesired station.

The unit starts scanning and tunes in a station automatically (seek tuning).

Press TUNE Y to decrease and TUNE A to increase the frequency.

Press the button again to cancel the function. Repeat the procedure until the desired station is tuned in.

Note

If you press (less than 0.5 second at a time) either TUNE V or TUNE A, the frequency decreases or increases step by step.

4 Adjust the volume with+/-.

5 ENGLISH

To turn the unit off

Press PWR.

Note

The “ST”indicator lights up when the tuned-instation is broadcasting in stereo and the reception is good.

PRESETTING STATIONS

1 23

1 Press PWR to turn the unit on.

2Press BAND to select a desired bsnd from among FM1, FM2, FM3, AM1, and AM2.

3Press and hold A.ME for more than 2 seconds to activate the automatic presetting function.

This unit can store up to 6 stations in memory for the preset station buttons 1 to 6 with “LO (local) indicator lighting up.

If the unit could not search for all of 6 stations, “LO (local) indicator goes off and starts searching for weaker stations again.

Use this function to automatically preset up to 6 stations each for FM1, FM2, FM3, AM1, and AM2 (up to a total of 30 stations).

When auto memory is completed, the station stored in the preset station button 1 is tuned in.

To stop auto memory, press A.ME again.

To checkthe presetstations(presetscan)

If you wish to check the preset stations, press A. ME forlessthan 2 seconds. The preset stations

stored in memory will be tuned in for 5 seconds

each in order.

To stop this function, press A.ME again or press any of the preset station buttons 1 to 6.

mm

ENGLISH 6

PRESETTINGSTATIONS

1 2

You can manually preset stations that have not been selected by auto memory.

1 3

4 2

1Press PWR to turn the unit on.

2Prees BAND to select the band from among FM1, FM2, FM3, AM1, snd AM2.

3Tune in the station that you wish to preset with TUNE Y or TUNE A.

4Prees one of the preset station buttons 1 to 6 for appro~mately 2 seconds.

While the station you are presetting is being registered in memory, the sound is momentarily muted.

The number of the pressed preset station button appears next to the frequency indication.

Presetlnumber

Repeat these procedures to preset up to 6stations each for FM1, FM2, FM3, AM1, and AM2.

If you try to preset a station on a preset station button on which another station of the same band has already been preset, the previously preset station will be erased.

3

1Prees PWR to turn the unit on,

2Press BAND to select a desired band from among FMI, FM2, FM3, AM1, and AM2.

3Press the desired preset station button.

The number of the-pressedpreset station button appears next to the frequency indication.

Active tuning reception control (ATRC)

This unit automatically suppresses FM noise caused by varying signal strength resulting from movement of the car.

The built-inautomatic blending circuit mixes the left and right channel signals according to the strength of the reception. At the same time, thehigh-cutcircuit activates to maintain the sound quality.

If the reception becomes even weaker, the unit automatically switches to Monaural mode, to reduce noise.

7 ENGLISH

MY INFORMATION

SWITCH

You can timer-activatethe radio for a daily radio program. The unit turnson and off in Radio mode at the preset time automatically.

2,4,7 3,6,8

5 1;9

1With the unit off, press snd hold MY INFO for more than 2 seconds.

The “PO indication flashes in the display window.

2Press SEL.

Timer indication flashes.

3Set the time you wish the unit to turn on in Radio mode.

Press TUNE Y to set the hour. Press TUNE A to set the minute.

4Press SEL.

Radio indication flashes.

Band indicator

5Press BAND to select the bsnd.

6Tune in the station that you wish to preset with TUNE V or TUNE A.

7Press SEL.

Timer indication flashes.

8Set the time you wish the unit to turn off .

Press TUNE V to set the hour. Press TUNE A to set the minute.

9Press snd hold MY INFO for more than 2 seconds.

Your sefting is stored in memory and the unit turns off.

ENGLISH 8

MY lltlF&’MlwlT/mSWITCH

CD PLAY

BAND

TAPE/MD

IN

( d,~,q

*-

)

D_

 

 

CD 1

~With the unit on, press MY INFO.

The “MYINFO indicator lights up and the timer is activated.

To cancel the timer

Press MY INFO again so that the “MYINFO indicator disappears.

To check the setting

With the unit off, press MY INFO.

The turn-ontime, followed by the radio frequency and theturn-offtime, appears in the display window each for 1 second, then the unit turns off.

Notes

Even if the unit is in a mode other thah Radio mode, the unit switches to Radio mode and tunes in the preset radio program at the preset time automatically.

Even if you are listening to a radio program with this function, pressing the following buttons switches the unit to other mode:

Pressing BAND changes the unit to Radio mode.

Pressing CD changes the unit to CD Play mode.

Pressing TAPE/MD IN changes the unit to TAPE/MD IN mode.

If you switch modes with these buttons, the unit does not turn off at the turn-offtime of the timer.

2

1Insert a disc with the labeled side upward to start CD play.

If a disc is already inserted, press CD to start CD play.

The track number and elapsed playing time appear.

CD indicator

Track n~mber Elap~edplaying time

2 Adjust the volume with+/-.

9 ENGLISH