AEG 8160 D User Manual

Size:
367.5 Kb
Download

8160 D

Cooker hood

Operating and Installation Instructions

Contents

 

Safety instructions .....................................................

2

Description of the cooker hood ...................................

3

Using the cooker hood ...............................................

4

Maintenance and cleaning ..........................................

5

What to do if ..............................................................

7

Service and Spare Parts .............................................

8

Customer Care ...........................................................

8

Guarantee Conditions .................................................

9

Technical data ..........................................................

10

Installation.................................................................

11

Safety instructions

These warnings are provided in the interest of your safety.Ensure that you understand them all before installing or using the appliance. Your safety is of paramount importance. If you are unsure about any of these meanings or warnings contact the Customer Care department

Please retain this instruction book for future reference, particularly if the appliance is sold or left to another person.

Installation and service

Any electrical installation of the cooker hood must be carried out by a qualified electrician and the hood itself must be installed by someone with experience. Installation made by an unqualified person can lead to loss of function of the cooker hood and possible damage to person and and/or property.

The cooker hood must be at least 50 cm above electric hobs or electric ranges, or at least 65 cm above gas burners or gas ranges.

Ensure that the power cable is not damaged during installation.

The cooker hood is only in stand by mode unless the plug or the fuse is disconnected.

The cooker hood cannot be connected to flues of other appliances that run on energy sources other than electricity. Please, keep to the provisions of official directives regarding fume discharge.

2

Use of the cooker hood

This appliance is for domestic use only in a normal household.

Never leave any deep-frying,melting fat, paraffin or any other inflammable liquid unattended on the hob. In the event of fire: Immediately switch off the cooker hood and the cooker.Note! Cover the fire. Never use water.

Never do any flambé cooking underneath the cooker hood. It can cause a fire. Remember that overheated fat may spontaneously ignite. Never leave the frying pan unattended.

It is essential that the grease filter is regularly cleaned to help avoid fat dripping on to the hot zone and causing a fire. Read the section on “Maintenance and Cleaning” in the instruction book.

Disposal

Prevent accidents when disposing of your cooker hood. Disconnect the power plug from the wall socket and cut the power cord at the hood inlet. Contact your local authority for information on where to dispose of the cooker hood.

Description of the cooker hood

Functions

There are two possible systems:

Extraction of air to the outside using an optional venting kit and evacuation duct.

Recirculation using an optional carbon filter.

Accessories Fig. 1

The following are included with the cooker hood.

1 Adaptor 150-125mm

2 Tube clamps

1 hood canopy complete with controls, lighting and fan motor.

1 telescopic chimney stack formed by: U-shapedupper section and U- shaped lower section.

1 reduction flange Ø 150-125mm.

1 recirculation spigot.

1 plastic bag containing: 2 wall hooks to fix the canopy hood, 1 wall bracket to fix the chimney, rawl plugs, screws, and documentation.

The following can be ordered from your retailer:

Carbon, KF8 filter, alternatively KFL 60/80.The carbon filter is to be used when the hood is connected to the recirculation mode.

3

Using the cooker hood

The control panel

Best results are obtained by using a low speed for normal conditions and high speed when odours are more concentrated.

The control panel has two switches; one for the lamp and one for the fan, enabling you to select one of three speeds. (Fig. 2).

Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared.

Fig. 2

Correct ventilation

If the cooker hood is to work correctly there must be an underpressure in the kitchen. It is important to keep the kitchen windows closed and have a window in an adjacent room open.

Important to know

Not applicable for recirculation. Great care must be taken if the hood is used at the same time as a burner or fireplace (e.g. gas, diesel, coal or wood heaters, water heaters, etc.), as the hood will expel air which is required by these other appliances. Attend to it by opening a window. The negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood.

4

Maintenance and cleaning

Before doing any maintenance work on the hood, disconnect it from the main supply by disconnecting the plug from the wall socket or unscrewing the fuse.

Cleaning the hood

Clean the outside of the hood using a damp cloth and a mild detergent. Never use corrosive, abrasive or flammable cleaning products.

Cleaning the grease filters

Clean the filter every month or every other month according to how much the hood is used. The cleaner the filters, the more grease they collect. Remove the filters by (Fig. 3):

Push the handle towards the rear of the hood.

Pull the filter down at the front

and remove it forwards.

The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent,

or in a dishwasher. Let the filter dry

before putting it back. Note that a

Fig. 3

dishwasher may discolour the filter.

Changing and cleaning the carbon filter

Only applicable for recirculation. The carbon filters absorb smells and odours.

Unlike other carbon filters, the LONGLIFE KF8 carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C.

The KFL 60/80 carbon filter can not be reactivated, it has to be changed after 6-8months of normal use.

5

After approximately three years of use, the KF8 filter should be replaced with a new, as the odour reduction capacity will be reduced.

To remove the filter (Fig. 4):

Remove the grease filters.

Press the red buttons (A), lower the front of the carbon filter.

Remove the carbon filter.

Replace in reverse order.

Fig. 4

Clean the filters regularly. The grease that collects in the filters and the duct could ignite if a hot plate is left on (or if overheating occurs).

Changing the light

Disconnect the cooker hood from the main supply before changing the light. To change the light (Fig. 5):

Remove the the glass diffuser.

Replace the old bulb with a new one of the same type.

Refit the glass diffuser.

Fig. 5

6

What to do if

If your appliance fails to work properly please carry out the following checks.

Symptom

Solution

 

 

The cooker hood will not start...

The hood is connected to the

 

electricity supply.

 

Check that the fan speed control is

 

set to 1, 2 or 3.

 

 

The cooker hood is not working

The fan speed is set high enough

effectively...

for the task.

 

The grease filters are clean.

 

The kitchen is adequately vented to

 

allow the entry of fresh air.

 

If set up for recirculation, check that

 

the charcoal filter is still effective.

 

If set up for extraction, check that

 

the ducting and outlets are not

 

blocked.

 

 

The cooker hood has switched off

The safety cut-outservice has been

during operation...

tripped.

 

Turn off the hob and then wait for the

 

device to reset.

 

If the hood has been installed below

 

the heights indicated in the

 

installation instructions the motor

 

will cut-outfrequently which will

 

damage the hood.

 

 

If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number.

Please note that it will be necessary to provide proof of purchase for any in-guaranteeservice calls.

In-guaranteecustomers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.

7

Service and spare parts

In the event of your apppliance requiring service, or if you wish to purchase spare parts, contact your local AEG Service Force Centre by telephoning

08705 929 929

Your call will be automatically routed to the Service Centre covering your post code area.

Please ensure that you have read the section „What to do if....“ as the engineer will make a charge if the fault is not a mechanical or electrical breakdown even the appliance is under warranty.

Please note that proof of purchase is required for in-guaranteeservice calls.

Help us to help you

Please determine your type of enquiry before writing or telephoning. When you contact us we need to know:

Your name

Address and post code

Telephone number

Clear and concise details of the fault

Name and model of the appliance*

E number*

*This information can be found on the rating plate, which can be seen when the grease filters are removed.

Customer Care

For general enquiries concerning your AEG appliances, or for further information on AEG products, please contact our Customer Care Department.

Customer Care Department

AEG Domestic Appliances 55-77High Street

Slough Berkshire SL1 1DZ

Tel.: 08705 350 350

8

Guarantee conditions

Guarantee Conditions

AEG offer the following guarantee to the first purchaser of this appliance.

1.The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.The guarantee does not cover commercial use.

2.The guarantee covers all parts or components which fail due to faulty workmanship or faulty materials. The guarantee does not cover appliances where defects or poor performance are due to misuse, accidental damage, neglect, faulty installation, unauthorised modification or attempted repair, commercial use or failure to observe requirements and recommendations set out in the instruction book.This guarantee does not cover such parts as light bulbs, removable glassware or plastic.

3.Should guarantee repairs be necessary the purchaser must inform the nearest customer service office (manufacturer`s service or authorised agent). AEG reserves the right to stipulate the place of the repair (i.e.the customer`s home, place of installation or AEG workshop).

4.The guarantee or free replacement includes both labour and materials.

5.Repairs carried out under guarantee do not extend the guarantee

period for the appliance. Parts removed during guarantee repairs become the property of AEG.

6. The purchaser`s statutory rights are not affected by this guarantee.

European Guarantee

If you should move to another country within Europe then your guarantee moves with you to your new home subject to the following qualifications:

-The guarantee starts from the date you first purchased your product.

-The guarantee is for the same period and to the same extent for labour and parts as exist in the new country of use for this brand or range of products.

-This guarantee relates to you an cannot be transferred to another user.

-Your new home is within the European Community (EC) or European Free Trade Area.

-The product is installed and used in accordance with our instructions and is only used domestically, i.e. a normal household.

-The product is installed taking into account regulations in your new country.

9

Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home.They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances.

France

Senlis

+33 (0) 44 62 29 29

Germany

Nürnberg

+49 (0) 911 323 2600

Italy

Pordenone

+39 (0) 1678 47053

Sweden

Stockholm

+46 (0) 8 738 7910

UK

Slough

+44 (0) 1753 219899

Technical data

Model

 

8160 D

Size

Height

800-1350mm

 

Width

598 mm

 

Depth

470 mm

Light

 

Max 1x11 W PL

Grease filter

 

2 pcs.

Voltage

 

220-240V

Total power

 

170 W

Fuse Rating

 

13 Amp

Extra accessories:

Carbon filter KF 8 (LONGLIFE)

P-nr.942 118 609

Carbon filter KFL 60/80

610 899 421

10