ADTRAN 1200153L2 User Manual

Size:
768.6 Kb
Download

Table of Contents

Express XR/XRT

128 kbps ISDN Modem

Quick Start Guide

1200153L1 Express XR, Data Only

1200153L2 Express XRT, Two Phone Ports 3360.9VU01 Express XR Power Supply, 9.0 V DC Output 336048VUR-2Express XRT Power Supply, 48 V DC Output

61200.153L1-13ESeptember 1996

Table of Contents

Trademarks

Express XR, Express XRT, and Express Configuration Wizard are trademarks of ADTRAN, Inc.

Hayes is a registered trademark of Hayes Microcomputer Products, Inc. HyperACCESS is a registered trademark of Hilgraeve Inc.

MicroPhone Pro is a trademark of Software Ventures Corporation. PROCOMM PLUS is a registered trademark of Datastorm Technologies, Inc. ReachOut is a registered trademark of Stac Electronics.

Windows is a registered trademark and Windows NT is a trademark of Microsoft Corporation.

pcANYWHERE is a trademark of Symantec Corporation.

The Express XR and Express XRT incorporate Synchronous Data Compression based on either IBM or Stac Electronics proprietary intellectual property depending on the time of manufacture. The following trademarks and copyrights are applicable:

Stacker LZS Compression

Copyright (c) 1989 Carnegie Mellon University.

All rights reserved.

Redistribution and use in source and binary forms are permitted provided that the above copyright notice and this paragraph are duplicated in all such forms and that any documentation, advertising materials, and other materials related to such distribution and use acknowledge that the software was developed by Carnegie Mellon University. The name of the University may not be used to endorse or promote products derived from this software without specific prior written permission. This software is provided "as is" and without any express or implied warranties, including, without limitation, the implied warranties of merchantability and fitness for a particular

901 Explorer Boulevard

P.O. Box 070020

Huntsville, AL 35807

Phone: (800) 8-ADTRAN

© 1996 ADTRAN, Inc.

All rights reserved.

Printed in USA.

Table of Contents

FCCregulationsrequirethatthefollowinginformationbeprovidedtothecustomer in this manual.

1.If your telephone equipment (Express XR/XRT) causes harm to the telephone network, the Telephone Company may discontinue your service temporarily. If possible, they will notify you in advance. But if advance notice isn’t practical, you will be notified as soon as possible. You will be advised of your right to file a complaint with the FCC.

2.Your telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the proper operation of your equipment. If they do, you will be given advance notice so as to give you an opportunity to maintain uninterrupted service.

3.If you experience trouble with this equipment (Express XR/XRT), please contact ADTRAN (see inside back cover) for repair/warranty information. The telephone company may ask you to disconnect this equipment from the network until the problem has been corrected, or until you are sure the equipment is not malfunctioning.

4.This unit contains no user-serviceableparts.

FEDERAL COMMUNICATIONS COMMISSION

RADIO FREQUENCY INTERFERENCE STATEMENT

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio or TV reception, which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by ADTRAN will void the user’s authority to operate this equipment.

CANADIAN EMISSIONS REQUIREMENTS

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causingequipment standard entitled "Digital Apparatus,"ICES-003of the Department of Communications.

Cet appareil nuerique respecte les limites de bruits radioelectriques applicables aux appareils numeriques de Class B prescrites dans la norme sur le materiel brouilleur: "Appareils Numeriques," NMB-003edictee par le ministre des Communications.

CANADIAN EQUIPMENT LIMITATIONS

Notice: The Canadian Industry and Science Canada label identifies certified equipment. This certification means that the equipment meets certain telecommunications network protective, operational, and safety requirements. The Department does not guarantee the equipment will operate to the user’s satisfaction.

Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the local telecommunications company. The equipment must also be installed using an acceptable method of connection. In some cases, the company’s inside wiring associated with a single line individual service may be extended by means of a certified connector assembly (telephone extension cord). The customer should be aware that compliance with the above conditions may not prevent degradation of service in some situations.

Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier. Any repairs or alterations made by the user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user to disconnect the equipment.

Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internal metallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas.

Caution: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or an electrician, as appropriate.

The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total of the Load Numbers of all devices does not exceed 100.

WARRANTY: ADTRAN warrants that items manufactured by ADTRAN and supplied under Buyer’s order shall be free from defects in materials and workmanship and will conform to applicable specifications and drawings. ADTRAN’s liability herein, whether based upon breach of warranty or contract or negligence in manufacture, shall be limited to replacement or repair at ADTRAN’s election of all such defective or nonconforming items, provided that this warranty shall apply only where Buyer has given ADTRAN written notice of such defects or nonconformity within five (5) years* after delivery by ADTRAN of such items to Buyer. ADTRAN shall have the right prior to return to inspect at Buyer’s plant any items claimed to be defective or nonconforming.

*Note: The following items carry warranty period as shown.

1.Items not of ADTRAN manufacture will carry the remaining warranty and related terms and conditions of the original manufacturer.

2.Encapsulated U-Repeaterand Encapsulated DDS Repeater - 2 years.

The foregoing constitutes the sole and exclusive remedy of the Buyer and exclusive liability of ADTRAN AND IS IN LIEU OF ANY AND ALL OTHER WARRANTIES EXPRESSED OR IMPLIED OR STATUTORY AS TO MERCHANTABILITY, FITNESS FOR PURPOSE SOLD, DESCRIPTION, QUALITY, PRODUCTIVENESS OR ANY OTHER MATTER. Without limiting the foregoing, in no event shall ADTRAN be liable for the loss of use or profit or other collateral, special or consequential damages.

RETURNS: Return authorization must be obtained from ADTRAN prior to return of any items, including those for repair. Buyer’s right to repair or replacement are governed by this Warranty. Issuance of credit for returned items shall be made at ADTRAN’s discretion upon Buyer’s request. All returns for credit accepted by ADTRAN are subject to a restocking fee.

SHIPPING: The cost of shipping the equipment from Buyer’s facility back to ADTRAN shall be paid by the Buyer. The cost for return shipping of the equipment by surface carrier shall be paid by ADTRAN. ADTRAN will utilize other means of express shipment at the request of the Buyer. The cost of shipping shall be paid by the Buyer if express shipment is requested. Inwarranty equipment returned for repair that is found not defective will carry a nominal charge to cover handling cost.

OUT OF WARRANTY: The cost ofout-of-warrantyrepairs including return shipment are subject to a charge as quoted by ADTRAN. The cost of the

Table of Contents

repair will be invoiced and the return of the item will be made using the most economical shipment means available. ADTRAN will use other means of express shipment at the request of the Buyer. In this case, the cost of shipping shall be paid by the Buyer.

ALTERATION TO EQUIPMENT PURCHASED: Modification or alteration to purchased equipment by Buyer, other than that specifically authorized by this Agreement or by ADTRAN, shall VOID AND NULLIFY, in its entirety, all warranty conditions as set forth in Warranty paragraph.

ENGINEERING CHANGES: ADTRAN reserves the right to make progress and design changes in standard product items ordered without prior approval or notification to Buyer and without incurring any obligations or liability to make the same changes in items previously manufactured.

DATA RIGHTS: Rights to any intellectual property residing in the products or any data furnished hereunder are not granted except by specific written permission by an authorized representative of ADTRAN. Buyer shall have no right to copy or reproduce in whole or part any data furnished hereunder without the prior written consent of ADTRAN.

PATENT AND COPYRIGHT INDEMNITY: ADTRAN warrants that the equipment and documentation furnished under this Agreement shall be free and clear of infringement of any patent or copyright covering the structure or composition of such articles or documentation. In the event of a claim, suit or action against Buyer alleging such infringement, ADTRAN shall save Buyer and its affiliates, agents or customers harmless from liability as finally determined by a court of competent jurisdiction, for such infringement, provided that Buyer gives ADTRAN notice promptly of such claim, suit or action, and shall have given ADTRAN full and exclusive control of the defense thereof, and that ADTRAN shall have sole right to settle or compromise such claim, suit or action.

In the event of a claim, suit or action against ADTRAN alleging infringement by the use of any such equipment or documentation, furnished under this Agreement, in combination with other articles or in carrying out any process covered by a patent owned or controlled by any other person, in which independent use of the equipment under this Agreement would not be an infringement. Buyer shall save ADTRAN harmless from Iiability, as finally determined by a court of competent jurisdiction, for such infringement, provided that ADTRAN shall have given Buyer full and exclusive control of the defense thereof, and that Buyer shall have the sole right to settle claim, suit or action.

Except as here in provided in this indemnity paragraph, neither Buyer nor ADTRAN makes any warranty to the other with respect to any claim, suit or action of any third party by way of infringement and neither party shall be responsible to the other for any loss, cost or damages consequential or otherwise, that may be suffered by the other as a result of any such claim, suit or action.

Table of Contents

Telephone Company Contacts for ISDN Service

Ameritech ISDN Repair

1-800-TEAMDATA

Bell Atlantic

1-800-204-7332

Bell South

1-800-247-2020

Cincinnati Bell

1-513-566-1611

NYNEX

1-800-NYT-FAST(New York Area)

 

1-800-650-ISDN(New England Area)

Pac Bell

811-8081*

Rochester Tel

1-716-777-1811

Southwestern Bell

1-214-841-7799(Dallas area)

 

1-800-286-8313(Houston area)

 

1-800-344-6357(Austin area)

 

1-314-571-2200(St. Louis area)

US West

1-800-223-7508

*all Pac Bell customers may call this number with no need for area code

Table of Contents

Table of Contents

Table of Contents

Chapter 1. Introduction

 

Express XR/XRT Overview ...................................................................................

1

Getting Started .........................................................................................................

1

Minimum Requirements .........................................................................................

2

What You Provide ............................................................................................

2

Basic Rate ISDN Line ................................................................................

2

What ADTRAN Provides ................................................................................

3

Chapter 2. Installation

 

Installing the ADTRAN Express XR/XRT ...........................................................

5

Verify Switch Settings ......................................................................................

5

Connecting the Express XR/XRT ...................................................................

6

Express XR/XRT Software Installation .........................................................

7

Microsoft Windows 95 and Windows NT 4.0 .......................................

8

Windows 95 Plug and Play ...............................................................

8

Win 95/NT4.0 Control Panel Modem Installation ........................

8

Express Configuration Wizard Installation ...........................................

9

Microsoft Windows 95 and Windows NT 4.0 ................................

9

Microsoft Windows 3.1 and Windows NT 3.51 ..................................

10

Windows NT 3.51 INF File Installation ........................................

11

Express Configuration Wizard Installation .........................................

11

Microsoft Windows 3.1 and Windows NT 3.51 ...........................

11

Basic Telephon Service ..................................................................................

12

Supplementary Voice Services .....................................................................

12

Call Waiting .............................................................................................

12

Conference Calling ..................................................................................

13

Automatic Redial.....................................................................................

13

Phone Number Allocation ............................................................................

13

Single Phone Number Operation .................................................................

13

Using the Express Configuration Wizard ...................................................

14

Auto-DetectSPIDs/Switch Type .................................................................

17

Using the Express Configuration Wizard Help .........................................

17

Express Configuration Wizard Tray Tool ...................................................

18

Express Configuration Tray Tool Menu .....................................................

21

Installing Windows 95 Dial-UpNetworking .............................................

22

Macintosh Configuration .....................................................................................

23

VT 100 Terminal Emulation .................................................................................

23

VT 100 Configuration.....................................................................................

24

VT 100 Terminal Status Buffer ......................................................................

24

61200.153L1-13

Express XR/XRT Quick Start Guide

i

Table of Contents

 

Chapter 3. Installing an Analog Modem

 

External Analog Modem Application .................................................................

27

Connecting an External Analog Modem.....................................................

28

Installing a New External Analog Modem .................................................

29

Configuring an External Analog Modem ...................................................

30

Required External Analog Modem Settings ........................................

30

Controlling an External Analog Modem ....................................................

31

Express Configuration Wizard Modem Enable ..................................

31

Express Configuration Wizard Modem Disable.................................

33

Terminal Emulation Modem Enable ....................................................

34

Terminal Emulation Modem Disable ...................................................

36

Internal Modem Application ...............................................................................

37

Connecting an Internal Analog Modem .....................................................

38

Chapter 4. Application Configuration

 

Factory Default Configuration.............................................................................

39

Profile Configurations ...........................................................................................

40

Express Configuration Wizard ............................................................................

41

Sarting the Express Configuration Wizard Software ................................

41

Internet and Remote Access ..........................................................................

41

Creating a Custom Profile ......................................................................

42

Defining a User Button ...........................................................................

42

BBS Applications ............................................................................................

44

Defining a Custom HyperACCESS Session ........................................

44

Chapter 4. Troubleshooting Guidelines

 

Troubleshooting Guidelines .................................................................................

47

Power/Line LED is Off..................................................................................

47

Power/Line LED Flashes and B1 and B2 LEDs are Off ............................

47

Power/Line LED, B1, and B2 LEDs Flash Green .......................................

48

Dial-UpConnection Problems ......................................................................

48

Auto-detectSwitch/SPIDs Remains at Link Down ..................................

48

Express XR/XRT Not Detected ....................................................................

48

External Analog Modem Not Detected .......................................................

50

Dial-UpNetworking Difficulty ....................................................................

50

Appendix A. AT Commands and S-Registers

 

AT Commands .......................................................................................................

51

S-RegisterList .........................................................................................................

57

Appendix B. LEDs

 

LEDs ........................................................................................................................

63

Appendix C. Status Messages

65

ii

Express XR/XRT Quick Start Guide

61200.153L1-13