Addonics Technologies ADSAIDE44 User Manual

Size:
208.04 Kb
Download

ADDONICS TECHNOLOGIES

Model: ADSAIDE44

Installation Guide

Front View

44-pinIDE Connector

SATA Power and

Master, Slave & Data Connector

Cable Select

Jumpers

Pin 1 Marker

2.Connect the converter board to the SATA connector of the hard drive.

3.(Optional) Connect the IDE ribbon cable to the 44-pinconnector on the converter. The red edge of the ribbon cable needs to line up to pin 1 marker of the44-pinconnector. The other end of the ribbon cable will be connected to your motherboard’s44-pinIDE channel.

Jumper Settings

Master

Slave

Cable Select

Note:

To set the SATA hard drive as a Master Device

 

when connected to an IDE channel, you need to

 

short the top pins located on the converter by

placing a jumper. As a Slave Device short the middle pins.

1.Locate the SATA connector of your 2.5” SATA drive.

15-pinSATA Power &

7-pinData Connector

TECHNICAL SUPPORT

Email: http://www.addonics.com/sales/ Internet: http://www.addonics.com

Technical Support (8:30 am to 6:00 pm PST) Phone: 408 573-8580

Email: http://www.addonics.com/support/ticketid/