Quick Installation Guide
STEP 1: CABLING
UTP Ethernet standard /cross-overcable
1-1.Connect the power adapter to this product and power it on.
The LED of Power will illuminate after this step.
1-2.Apply the UTP cable to connect your Cable/DSL modem to this product’s Internet port.
The LED of Internet will illuminate after this step.
1-3.Use a network cable to connect your PCs’ Ethernet ports to one of this product’s LAN (1 to 4) ports.
The LED of LAN port you plugged into will illuminate after this step.
STEP 2: INSTALLING WIZARD
Note: To configure this device, you must have IE 4.01 or above installed.
1.Load the setup CD-ROMonto your computer. Theauto-execution file will start automatically.
2.Select Quick Setup Wizard.
3.The self-explanatorywizard will guide you through the installation procedure. Follow theon-screeninstruction to proceed.
STEP 3: CHECKING THE INTERNET CONNECTION
You can open a new web browser to surf the Internet now. Should the access fail, you can check by the following steps: 3-1.go to 192.168.1.254;
3-2.selectNetwork status\WAN IP Status in the left pane,
3-3.if the IP address field displays anything except 0.0.0.0, it means the Internet connection is well established. Otherwise (as illustrated below), repeat the whole procedures.
Internet connection is not successful.