3M 3M-MATIC L-CLIP APPLICATOR S-867 BROCHURE User Manual
increases productivity, reduces operating expense
Full pneumatic operation with no electric power needed.
•Air pressure and flow controls optimally positioned to reduce unnecessary operator adjustments, improve ease of maintenance access, and add floor layout versatility
•Ability to position taping heads closer together to apply clips as close as 8" apart
•Wide selection of tape widths: 9mm, 12mm, 15mm, 18mm, 24mm, and 36mm.
Easy and intuitive to use, the
Consistent tape length
•Conserves tape with virtually no waste
Easy versatile placement
• Small footprint of only 31" x 29"x 11"
•Easy open access for tape threading
•Automatically shuts off air pressure when opened
• For mounting
and case handling
Length: 2.25" to unlimited Width: 5" to unlimited Height: 2.25" to unlimited
•Safely activates unit when case is pressed against the plate
• Conveniently located for quick access
Air pressure and flow controls
• Positioned for easy maintenance
lower profile cases
Bottom taping position:
Top taping position:
Note: Operator will determine maximum height, width, length, and weight. Please contact your 3M sales professional for assistance in determining proper equipment layout and
Scotch® Filament Tape.
Width: 3/8 inch [9mm] minimum to 1 1/2 inch [36mm] maximum Roll diameter: up to 15 inches [380mm] maximum on a 3 inch [76.2mm] diameter core.
Applied tape length: 4.5 inches [115mm] (normal). Tape legs are 2.25 inches± .125 inches [55mm ± 3.2mm]
Cycle time: 1.2 seconds Power:
60 to 65 psig [515 kPa - 560 kPa]
2.16 SCFM [3.65 m3/h 21°C, 101 kPa] at a maximum cycle rate. A pressure
Length: 31 inches [790mm]
(includes 360 yard [330m] tape roll
Height: 29 inches [735mm]
(includes 360 yard [330m] tape roll Width: 11 inches [280mm]
Weight: 75 lbs.[34kg] unpackaged 83 lbs. [37.7kg] packaged
Operating conditions: Use in dry, relatively clean environments at 40°F to 120°F with clean, dry boxes.
Note: Machine should not be washed down or subjected to conditions causing moisture condensation on components.
Please contact your 3M sales representative or call
Right Side View
A B C D E
Product Use: User is responsible for determining whether the product is fit for a particular purpose and suitable for user’s method of application.
Warranty and Limited Remedy: THE FOLLOWING WARRANTIES ARE MADE IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED
TO THE IMPLIED WARRANTY OF MERCHANTABILITY, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE AND ANY IMPLIED WARRANTY ARISING OUT OF A COURSE OF DEALING, A CUSTOM OR USAGE OF TRADE: 3M warrants that its
Limitation of Liability: 3M and seller shall not be liable for direct, indirect, special, incidental or consequential damages based upon breach of warranty, breach of contract, negligence, strict liability or any other legal theory.
The foregoing Warranty and Limited Remedy and Limitation of Liability may be changed only by a written agreement signed by authorized officers of 3M and seller.
Industrial Adhesives and Tapes Division
900 Bush Ave.
St. Paul, MN 55106
Printed in U.S.A. © 3M 2005